Handleiding
Je bekijkt pagina 52 van 60

Installation Procedure
52
English
Installation Procedure
(*1) When Cooling or dry mode is off. The indoor fan operate in setting minutes.
(*2) Minimizing fan operation when thermostat is off
- Fan operates for 20 seconds at an interval of 5 minutes in Heat mode.
- Fan stops or operates Ultra low in Cooling when thermostat is off.
(*3)
1: Fan is turned on continually when the hot water heater is turned on,
3: Fan is turned off when the hot water heater is turned on with cooling only indoor unit
Cooling only indoor unit: To use this option, install the Mode Select switch(MCM-C200) on the outdoor
unit and
fix it as Cool mode.
(*4) When the following 2 or 3 is used as external heater On/Off signal, the signal for monitoring external
contact control will not be output.
2: Fan is turned on continually when the external heater is turned on,
3: Fan is turned off when the external heater is turned on with cooling only indoor unit
Cooling only indoor unit: To use this option, install the Mode Select switch(MCM-C200) on the outdoor
unit and
fix it as Cool mode.
- If Fan is set to off for cooling only indoor unit by setting the SEG9=3 or SEG15=3, you need to use an
external sensor or wired remote controller sensor to detect indoor temperature exactly.
(*5) When indoor unit is in cooling or Dry mode, The output signal is “ON”
(*6) For free cooling control, Economizer controller is required.
(*7) This function can be applied to 4 Way Cassette and Mini 4 Way Cassette only.
If the air conditioner operates the heating mode immediately after finishing the cooling mode, the
con
densate water in the drain pan becomes water vapor by the heat of the indoor unit heat exchanger.
Since the water vapor might be condensed on the indoor unit, which may fall into a living space, use
this function to get rid of the water vapor out of the indoor unit by operating the fan (for maximum 20
minutes) even when the indoor unit is turned off after cooling mode is turned to heating mode.
(*8) Soft Off: If no motion is detected for the Soft Off time, the MDS Kit turns off the indoor units.
Then if any motion is detected until the Hard Off time is passed, the MDS Kit restarts the indoor
units
.
(*9) Hard Off: If no motion is detected for the Hard Off time, the MDS Kit turns hard off the indoor units.
Then although any motion is detected, the MDS Kit does not restart the indoor and outdoor
units
.
You must manually restart the units with the wired or wireless remote control.
DB68-13032A-00_IBIM_DVM R32 WindFree 1,4way_EU_EN_.indd 52DB68-13032A-00_IBIM_DVM R32 WindFree 1,4way_EU_EN_.indd 52 2024-07-29 오전 10:10:532024-07-29 오전 10:10:53
Bekijk gratis de handleiding van Samsung AM140DN4DKG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Samsung |
| Model | AM140DN4DKG |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 5649 MB |







