Sagitter J-TUBE X1 handleiding
Handleiding
Je bekijkt pagina 32 van 48
32
5.7 – REMOTE CONTROLLER (SG JTUBEX1REMOTE sold separately)
OPERATION
1. Before to use, each remote controller must be linked to each tube. The link can be done
on 4 different frequencies (4 groups)
2. Before the link, check that, under the submenu SETUP, all the tubes to link have the
option REMOTE = OFF
3. In the remote controller press and hold the button until the LED 1 is green fixed
4. Press and hold the button until the LED 1 starts to blink
5. When this LED 1 blinks, set the group to which the tubes must be linked. The settings of
the group can be done by pressing 1 time the button until the LED of the selected
group (1, 2, 3, 4) starts to blink
6. After the setting described to the point before is done, it is possible to switch ON the
receivers of the remote controllers on the tubes that must be linked to this group. In the
submenu SETUP / REMOTE, set ON and press ENTER. The tube will blink 3 times white
color. This indicates that the tube is linked to the selected group.
7. WARNING: the link operation to a specific group, is possible only during the time when
the specific LED of the group is blinking. When the LED stops to blink (after
approximately 1 miute) it is not possible to link other tubes. Repeat the procedure
described before from point 3 to point 6.
8. In order to link another group of tubes, repeat the procedure described before from the
point 3 to point 6. Pay attention that on the remote controller another group must be
selected (LED of the selected group blinking).
Bekijk gratis de handleiding van Sagitter J-TUBE X1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sagitter |
| Model | J-TUBE X1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7346 MB |
