Handleiding
Je bekijkt pagina 33 van 41
- Ensure the thickness of the work surface is at least 30mm.
Please select heat-resistant work surface material to avoid
larger deformation caused by the heat radiation from the
hotplate. As shown below:
• Put a towel or cloth on the work surface. Place the hob face
down on the protected surface.
• Apply the strip seal, supplied with the hob, which is for sealing
it onto the work surface.
Do not use silicone. Apply the seal to the edge of the bottom of
the hob, leaving about 3mm from the edge of the glass. Apply the
seal all around the circumference.
Cut any excess and bring the two ends of the seal together so they
match.
Seal
Warning: The work surface material must be made of impregnated
wood or other insulation material.
Glass
surface
Bottom of hob
Cloth
Self-
adhesive seal
Type L(mm) W(mm) H(mm) D(mm) A(mm) B(mm) X(mm)
590 520 60 56 560 490 50
TI72001FLX25/A
Under any circumstance, make sure the hob is well
ventilated and the air inlet and outlet are not blocked.
Ensure the hob is in good work state. As shown below.
Note: The safety distance between the hotplate and the cupboard
above the hotplate should be at least 760mm.
GB GB
63
62
A(mm)
760
B(mm)
50 mini
C(mm)
20 mini
D
Air intake
E
Air exit
5mm
L
W
D
H
X
B
X
A
X
X
Seal
A
C
E
B
D
board
product
560
490
Bekijk gratis de handleiding van Saba TI72001FLX25/A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Saba |
| Model | TI72001FLX25/A |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 5355 MB |
