Rowenta X-Plorer Serie 220 RR9495 Handleiding (137 Pagina's)

Handleiding

16 17

Wash the mop cloth under water or in the laundry machine. Let it dry for 24 hours.

Please replace the mop cloth after 100 washes. You can buy kit of new mops on

www.rowenta.com

Use the robot with the mopping function

(«vacuum & mop» mode)

EN

At the end of the cleaning session, unclip the water tank by pressing the latch and pull

to remove the water tank. Empty the water tank of the remaining water. Remove the

dirty mop cloth.

Install the « vacuum only » module for charging.

Flash the QR-Code above to know how to use the maintain the robot to keep its performance.

Always switch off the robot by pressing and holding the START button for 5 seconds, and

unplug the station before any manipulation.

Maintain the robot and its accessories

Once a week, clean the sensors

With a clean, soft and dry cloth, wipe the robot sensors (in front, top, back and bottom of the

robot) and the sensors and charging contacts of the station.

Wipe the two buttons on top of the robot.

After each use, clean the dust box

At the end of the cleaning session, the robot returns to its station and automatically empties the dust box,

but some dirt may remain in the dust box. Open the ip cover, take the dust box handle and lift the dust

box by the handle to take it out of the robot. Push on the latch on the side of the dust box to open. Empty

the dirt into the bin. Close the dust box.

Note: The ip cover may not open or close properly if there is too much dust in the hinges. Please clean

hinges with a clean, soft and dry cloth to remove dust.

EN

Bekijk gratis de handleiding van Rowenta X-Plorer Serie 220 RR9495, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.