Roland S-2416 handleiding
Handleiding
Je bekijkt pagina 11 van 28
11
Preparations for Power-Up
Connecting the Power Cord
Connect the included power cord to the AC IN connector on rear
panel. Be sure to use the included power cord for connecting the
power supply.
NOTE
Be sure to connect the power plug only to a power outlet that
meets the specications given on the rating plate. The rating
plate is located on the rear panel.
About Cord Hook
Secure the power cord in place using the cord hook as shown
below.
This can help prevent power loss due to the plug being pulled out if
the power cord is accidentally yanked.
Turning the Power On and O
* Before turning the unit on/o, always be sure to turn the volume
down. Even with the volume turned down, you might hear some
sound when switching the unit on/o. However, this is normal
and does not indicate a malfunction.
Turning the power on
* Once everything is properly connected (p. 17), be sure to follow
the procedure below to turn on their power. If you turn on
equipment in the wrong order, you risk causing malfunction or
equipment failure.
1. Turn on the power to equipment connected to INPUT on
the S-2416.
2. Turn on the [POWER] switch on the S-2416.
The POWER indicators (front and rear) light up.
Rear panel
* This unit is equipped with a protection circuit. A brief interval (a
few seconds) after turning the unit on is required before it will
operate normally.
3. Turn on the power to equipment (such as power ampliers
and monitor speakers) connected to OUTPUT on the S-2416.
Turning the power o
1. Lower the volume and turn o the power to equipment
(such as power ampliers and monitor speakers) connected
to OUTPUT on the S-2416.
2. If you’re using an S-4000R unit, press the [LOCK] button
on the S-4000R to switch locking on or o.
This turns locking o if currently on, or on if currently o.
The parameter settings on the S-2416 are saved in the S-2416 unit
when this switching takes place.
3. Turn o the [POWER] switch on the S-2416.
The POWER indicators (front and rear) go dark.
4. Turn o the power to equipment connected to INPUT on
the S-2416.
* If you need to turn o the power completely, rst turn o the
unit, then unplug the power cord from the power outlet. Refer
to “To completely turn o power to the unit, pull out the plug
from the outlet” (p. 3).
Bekijk gratis de handleiding van Roland S-2416, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Roland |
| Model | S-2416 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5368 MB |
