Roland S-0808 handleiding
Handleiding
Je bekijkt pagina 27 van 36
27
Appendices
Power Supply
No power is supplied by REAC EMBEDDED POWER.
Does the connected device supply REAC EMBEDDED POWER? Is the REAC connection cable free of broken wires or other
problems?
To receive REAC EMBEDDED POWER, an S-4000M, S-4000D, or other source device of REAC EMBEDDED POWER must be
connected. For information on cables for REAC connections, refer to “Before Making REAC Connections” (p. 13).
The S-0808 may not boot up correctly if the power supply from your REAC EMBEDDED POWER device is stared while S-4000R is
connected to S-0808’s REMOTE connector. Disconnect the S-4000R and start power from your REAC EMBEDDED POWER device
first. Check that S-0808 is booted correctly and then connect the S-4000R.
No power is supplied by the external battery.
Is the battery compatible with the rated voltage of the S-0808?
When receiving power from an external battery, the voltage must be between 12 V and 18 V. Check the output voltage of the
battery. Also, batteries for broadcast video-cameras have a feature to display the remaining charge. Check the remaining charge
before connecting.
Input and Output
No input or output is possible.
Is the operation mode set correctly?
REAC has the following three operation modes, and the mode setting for each connected REAC device must be made correctly.
Making the wrong settings may result in incorrect audio input and output.
• M The unit functions as a REAC master device.
• S The unit functions as a REAC slave device.
• SP The unit functions as a REAC split device.
For information about the various connection methods and their corresponding operation-mode settings, refer to “Connecting
REAC Devices”(p. 13).
The volume of the instrument connected to INPUT 1 - 8 is too low.
Could you be using a connection cable that contains a resistor ? Use a connection cable that does not contain any resistor.
The output level is too high.
Does the nominal input level of the output-destination device (amp, speaker, deck, or the like) match the output level of the
S-0808?
The output level of the S-0808 is +4 dBu (nominal, maximum: +22 dBu). If the output level is too high even when the input gain
has been turned down on the output-destination device, interpose an attenuator between the output-destination device and the
S-0808. Adjustment can also be made by lowering the preamp gain on the S-0808, but this may result in a poor signal-to-noise
ratio.
Troubleshooting
Bekijk gratis de handleiding van Roland S-0808, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Roland |
| Model | S-0808 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5626 MB |
