Robot Coupe MP 350 Turbo V.V. handleiding

Blender

Robot Coupe

62 pagina's

PDF beschikbaar

Handleiding

TROUBLE SHOOTING

• THE POWER MIXER DOES NOT START.

1. Did you follow the previous operating instructions

? (See section-Operating The Power Mixer).

2. Is the machine too hot ? Allow the power mixer

to cool. Then retry.

3. Pull the plug and try another outlet.

4. Check the GFI trip indicator on your outlet.

Check the circuit breaker.

5. Call local Robot Coupe authorized service

agency.

• THE POWER MIXER STOPS DURING (WHILE)

PROCESSING.

See the section On Operating the Power Mixer.

- The first paragraph describes the overload protection.

It may be necessary to allow the machine to cool

for up to 30 minutes before restarting.

If you cannot locate the cause of the problem

- Release the control button (CB).

- Unplug the power mixer.

- Are the blades free to rotate in the bell ?

- Is the drive shaft free to rotate ? To check this,

unplug the power mixer, remove the bell and test the

rotation of the end of the drive shaft manually.

Check the condition of the plug and the power cord.

• THE POWER MIXER STARTS TO SMELL HOT

OR SMOKE

- Turn the power mixer off and unplug it.

- Call your local authorized service agency.

• THE MACHINE TRIPS THE GFI (Ground fault

Interrupt) OUTLET

The motor or controls are wet or damaged. Do not

attempt to use the mixer until it has been repaired

by qualified service persons.

• OVERLOAD WARNING LIGHT

(MP 600

Turbo and MP 800 Turbo

)

In case of overload or

use of the mixer in a too

sticky preparation, the

intensity warning flashes

for 5 seconds to inform

you that the motor will

stop shortly. This stop

indicates that the prepa-

ration in process is too

thick or can not be made

with a stick blender.

In this case, you can still restart your mixer.

However, your machine will stop again if the

consistency of the preparation is not modified.

SERVICE

See warranty first then;

Should your unit require service, check with your

distributor to see where local service is available.

If not or if you wish your unit to be serviced at the

factory, call for return instructions and ship the unit

prepaid to our factory address.

PH : 1-800-824-1646

Robot-Coupe USA, Inc

Service Department Repair

264 South Perkins Street

Ridgeland, MS 39157

For service in Canada contact the Robot-Coupe

USA factory for repair instructions.

FLASH

WARNING

• THE BLADES ARE SHARP! It is recommended

that cutting gloves be worn when handling

the blades. Handle and store the blades with

safety in mind.

• Never try to defeat the safety mechanisms!

• Never put anything (utensils etc.) but food

material near the blades on the power

mixer!

• Never overload the power mixer!

• Never turn the power mixer on unless the

bell is completely immersed in the product.

• Always unplug the power mixer before

doing any cleaning or maintenance!

Bekijk gratis de handleiding van Robot Coupe MP 350 Turbo V.V., stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.