Handleiding
Je bekijkt pagina 15 van 40
Rinnai 15 GD OIM
HOW TO USE A TIMER PROGRAM
1. Open the dryer door and place items selected for
drying evenly into the dryer drum and close the door.
2. Press the ON/OFF button, the dryer will turn ON,
and defaults to the last setting that was used.
3. If not already in TIMER mode, press the TIMER
button. The TIMER indicator illuminates and the
TIMER SETTING indicator will also begin to ash.
NOTE
The digital display will now show a set
drying time from one of the pre-set times
available (5, 10, 15, 20, 25, 30, 40, 50, 60, 70,
80, 90). Set time defaults to that last used.
4. To adjust the set drying time, press the UP or DOWN
buttons to select the next pre‑set time.
5. Press the START/PAUSE button, the TIMER
SETTING indicator will go out to signify that a
TIMER operation has now begun.
The OPERATION (Combustion) indicator will show
green, and changes to red after the burner ignition
which may take up to 10 seconds, after which drying
commences. The drying time in the digital display
and will also begin to be counted down in 5 minute
increments until there is only 1 minute remaining.
NOTE
During operation the drying time may be
increased or decreased to the next pre-set
time by pressing the UP or DOWN buttons.
The OPERATION (Combustion) indicator
may alternate between showing green and
red, and will show green towards the end
of the drying cycle, however this is normal.
If the dryer door is opened during operation
the dryer will be paused and resume once
the door is closed.
Dryer operation will stop when the set drying time
has elapsed and 3 long beeps will sound 3 times.
The OPERATION (Combustion) indicator will show
green and the SOFTEN & COOL indicator will begin
to ash.
NOTE
At this point the items may be removed if
so desired. Before opening the dryer door,
ensure the SOFTEN & COOL indicator is
ashing.
If no action is taken the SOFTEN & COOL
function will begin.
6. Approximately 1 minute after the dryer program
nishes the SOFTEN & COOL function will begin.
The SOFTEN & COOL indicator will now be ashing
steadily and the dryer will automatically turn OFF
once the SOFTEN & COOL function is completed.
NOTE
Refer to the section "Soften & Cool
Function" on page 11 for instruction on
how to cancel operation.
2
BEEP
3
BEEP
3 ~ 76 min
5
BEEP
Red Green
1 min
OFF!
4
BEEP
6
3 BEEPS x 3
~10 sec
Green Red
Clicks
in place
Clicks
in place
1
OPERATION
Bekijk gratis de handleiding van Rinnai Dry-Soft 9 DRYSOFT9N, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rinnai |
| Model | Dry-Soft 9 DRYSOFT9N |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 5820 MB |
