Handleiding
Je bekijkt pagina 14 van 40
Rinnai 14 GD OIM
HOW TO USE AUTOMATIC PROGRAMS
1. Open the dryer door and place items selected for
drying evenly into the dryer drum and close the door.
2. Press the ON/OFF button, the dryer will turn ON,
and defaults to the last setting that was used.
3. If not already in Automatic Program mode, press
the PROGRAM button by default the GENERAL
program will be illuminated.
To select an alternative program press the
PROGRAM button until desired program indicator
is illuminated. The order that the programs cycle
through is as followings: GENERAL THICK
SHEET/BLANKET ECO
4. Press the START/PAUSE button. The OPERATION
(Combustion) indicator will show green, and
changes to red after the burner ignition (which may
take up to 10 seconds), drying will commence after
ignition.
After approximately 2 minutes of operation an
estimate of the remaining drying time will appear
in the digital display and count down in 5 minute
increments until there is only 1 minute remaining.
NOTE
The OPERATION (Combustion) indicator
may alternate between showing green and
red, and will show green towards the end
of the drying cycle, however this is normal.
When the front door is opened during
operation, the operation/combustion lamp
lights (green) and operation stops. Drying
operation is resumed when the front door
is closed. If drying operation is continued
immediately after cooling operation, drying
operation begins immediately after cooling
operation of two minutes maximum.
Dryer operation will stop when items are suciently
dry and 3 long beeps will sound 3 times.
The OPERATION (Combustion) indicator will show
green and the SOFTEN & COOL indicator will begin
to ash.
NOTE
At this point the items may be removed if
so desired. Before opening the dryer door,
ensure the SOFTEN & COOL indicator is
ashing.
If no action is taken the SOFTEN & COOL
function will begin.
5. Approximately 1 minute after the dryer program
nishes the SOFTEN & COOL function will begin.
The SOFTEN & COOL indicator will now be
illuminated and the dryer will automatically turn OFF
once the SOFTEN & COOL function is completed.
NOTE
Refer to the section "Soften & Cool
Function" on page 11 for instruction on
how to cancel operation.
2
BEEP
3
BEEP
4
BEEP
~10 sec
Green Red
Red Green
~2 min
3 ~ 76 min
1 min
OFF!
Clicks
in place
Clicks
in place
1
6
ECO
3 BEEPS x 3
OPERATION
Bekijk gratis de handleiding van Rinnai Dry-Soft 9 DRYSOFT9N, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rinnai |
| Model | Dry-Soft 9 DRYSOFT9N |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 5820 MB |
