Handleiding
Je bekijkt pagina 27 van 40
Rinnai 27 GD OIM
WALL MOUNTING BRACKET ASSEMBLY
The wall mounting bracket is provided in kit form with the following components:
1 x Wall Fame
1 x Support Frame
4 x Hex Head Bolts and Washers
4 x Mounting Screws and Washers
Some minor assembly is required before the wall mounting bracket can be xed to the wall. To assemble the wall
mounting bracket use the four hex head bolts and washers provided and securely attach the support frame to the
wall frame. Attached the wall mounting bracket to a suitable wall with appropriate xings (not supplied).
WALL MOUNTING BRACKET & DRYER INSTALLATION
1. Attach the tabbed mounting plates x 4 (supplied with dryer) onto mounting points, ensure the tabs of these
plates align with the 2 holes in the mounting points. Secure in place using the provided countersunk screws.
2. Lift the dryer onto the installed wall mounting bracket taking care to locate the four securing holes of the
support frame with the four rear most holes of the installed mounting plates.
3. Secure the dryer to the frame through the rear most holes of the tabbed mounting plates using the four
mounting screws and washers provided with the wall mounting bracket.
Wall frame
Mounting screws and washers x 4
Support frame
Hex head bolts
& washers x 4
Mounting screw & washer
Mounting screws & washers x 4
Securing holes x 4
Plastic molded feet
The plastic molded feet
are affixed to dryer with
a single screw
Securing hole
Rubber
foot
GENERAL INSTALLATION INFORMATION
Bekijk gratis de handleiding van Rinnai Dry-Soft 9 DRYSOFT9L, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rinnai |
| Model | Dry-Soft 9 DRYSOFT9L |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 5820 MB |
