RIDGID WD19560 handleiding
Handleiding
Je bekijkt pagina 6 van 40
ASSEMBLY
6
METAL HANDLE INSTALLATION (Fig. 2)
Your Metal Handle (Q) comes packaged in the Carton in
the reverse direction.
You MUST pull the Metal Handle (Q) completely out of
Handle Receptacles in Dust Drum Assembly (B) and
reinstall the Metal Handle (Q) in the correct direction,
bent area facing away from the back of the Vac, before
continuing.
1. Press and hold Release Buttons while installing
Metal Handle (Q) into Handle Receptacles in Dust
Drum Assembly (B).
NOTE: An audible snap of Release Buttons indicates
successful engagement of Metal Handle.
Fig. 2
Metal Handle in Reversed
Position (As Shipped)
(Q)
Handle
Receptacles
(B)
Correct Position
SP7156 ESF.indb 6SP7156 ESF.indb 6 5/8/24 10:09 AM5/8/24 10:09 AM
METAL HANDLE STORAGE & REMOVAL (Fig. 3)
1. Lowering Metal Handle for Storage: To store Wet/
Dry Vac, press and hold Release Buttons while
firmly sliding Metal Handle (Q) down.
2. Removing Metal Handle: Press and hold Release
Buttons, as shown. While firmly pushing in Release
Buttons, pull Metal Handle (Q) upwards to remove.
Fig. 3
Moving Position
Storage
Position
(Q)
Handle
Receptacles
(2)
Release
Buttons (2)
TOOL HOLDER INSTALLATION (Fig. 4)
1. Position the Tool Holder (O) (extension wand
storage locations facing unit) on the Metal
Handle (Q).
2. Install the Tool Holder (O) by wrapping the Five Tote
Straps around the Metal Handle (Q) and Snap each
Strap in place.
Fig. 4
Tote Snaps
Tote Straps (5)
(Q)
(O)
Extension Wand
Storage Locations
(Not on all models)
Bekijk gratis de handleiding van RIDGID WD19560, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | RIDGID |
| Model | WD19560 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 6967 MB |
