RIDGID 918-5 handleiding
Handleiding
Je bekijkt pagina 19 van 111
17
918 Roll Groover
999-998-946.10_REV D
Figure 22 – Checking Groove Diameter with a Diameter
Tape
Preparing Machine for Transport
Before transporting, remove the 918 from the power
drive/threading machine. Be aware of the equipment
weight. Use appropriate methods when lifting or moving.
Storage
The 918 Roll Groover must be kept in-
doors or well covered in rainy weather. Store the machine
in a locked area that is out of reach of children and peo-
ple unfamiliar with roll groovers. This machine can cause
serious injury in the hands of untrained users.
Maintenance Instructions
WARNING
Make sure machine is unplugged from power
source before performing maintenance or making
any adjustments.
Maintain the 918 Roll Groover according to these
procedures to reduce the risk of injury.
Cleaning
Use a soft damp cloth to clean the roll groover.
Clean the drive roll knurls with a wire brush before use
and as necessary during operation. When grooving stain-
less steel pipe, thoroughly clean the entire roll set with a
stainless steel wire brush.
Lubrication
On a monthly basis (or more often if needed), lubricate
the groover with a lithium based general purpose grease.
Always lubricate the roll groover after roll set changes.
Figure 21 – Applying Pressure on Pipe with Power Drive
in FOR direction
Inspect/Measure the Groove
1. Inspect the groove.
• Make sure that all features are present and fully
formed. See Table II and Figure 31.
• Measure the groove diameter and make sure it is
within specification.
• Check any other items required by the fitting man-
ufacturer.
• Test the system in accordance with local codes
and normal practice.
If any problems are found, the groove cannot be
used. Proper groove diameter is important to ensure
connection performance. Out of specification grooves
could cause joint failure.
2. Measure the groove diameter with diameter tape (see
Optional Equipment Section). Snugly wrap the diam-
eter tape around the pipe in the groove. Make sure
that the tape sits flat in the bottom of the groove, and
read the groove diameter (see Figure 22). Compare
the measured groove diameter to the required groove
diameter as shown in Table II or III or as specified by
the groove fitting manufacturer.
17
WARNING
Bekijk gratis de handleiding van RIDGID 918-5, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | RIDGID |
| Model | 918-5 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 42226 MB |
