Rheem 876A26PF handleiding
Handleiding
Je bekijkt pagina 7 van 48
7
SAFETY, WARNINGS, INSTALLATION NOTES
It is important you read the following safety and warnings information.
SAFETY AND WARNINGS
• The water heater heats the water to the preset outlet temperature setting if a temperature controller is not
installed. The outlet temperature setting can be up to 75°C for an 874 series water heater or up to 50°C
for an 876 series water heater. If an 874 series water heater is installed as part of a solar water heater
system, the system can deliver water at temperatures from 58°C up to 80°C and possibly higher
depending upon the model of solar water heater installed.
These temperatures from an 874 series water heater are sufficiently hot to cause severe scalding. Water
at this temperature may have been plumbed to fixtures where water hotter than 50°C is allowed, such as
the kitchen and laundry.
Refer to:
“How Hot Should the Water Be?” on page 11, and
“Hotter Water Increases the Risk of Scald Injury” on page 11.
• This water heater is only intended to be operated by persons who have the experience or the knowledge
and the capabilities to do so.
• This water heater is not intended to be operated by persons with reduced physical, sensory or mental
capabilities i.e. the infirm, or by children. Children should be supervised to ensure they do not interfere
with or play with or at the water heater.
• If the power supply cord or plug is damaged, it must be replaced by a qualified person in order to avoid a
hazard. The power supply cord and plug must be replaced with a genuine replacement part available from
Rheem. Phone Rheem Service or their nearest Accredited Service Agent to arrange for an inspection.
• The power lead from the water heater must be plugged into a weatherproof electrical outlet. Take care
not to touch the power plug with wet hands.
• The water heater uses 220 V – 240 V a.c. electrical power for operation of the control systems and the
combustion fan. The removal of the front panel will expose 220 V - 240 V a.c. wiring. It must only be
removed by a qualified person. Do not operate the water heater with the front panel removed.
• This water heater is supplied with temperature sensors, a FlameSafe
®
protection system and a pressure
relief valve. These devices must not be tampered with or removed. The water heater must not be operated
unless each of these devices is fitted and is in working order.
The Rheem warranty may not cover faults if safety devices or the relief valve are tampered with or
if the installation is not in accordance with these instructions.
• Temperature controllers must not be fitted to this water heater (874 series) if it is installed as an in-series
gas booster with a solar water heater system because water at a temperature much higher than the
controller setting can be delivered. If a solar water heater is installed to an existing water heater
installation, then all controllers must be disconnected and removed.
• For continued safety of this water heater it must be installed, operated and maintained in accordance with
the Owner’s Guide and Installation Instructions.
• Servicing of the water heater must only be carried out by qualified personnel. Phone Rheem Service or
their nearest Accredited Service Agent.
• Do not modify this water heater.
• Switch off the electrical supply at the power outlet to the water heater prior to performing general
maintenance. This will prevent the water heater from operating while you clean or spray around the water
heater.
Refer to “General Maintenance” on page 15 for additional information.
Bekijk gratis de handleiding van Rheem 876A26PF, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rheem |
| Model | 876A26PF |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7567 MB |