Rheem 876A26PF handleiding
Handleiding
Je bekijkt pagina 19 van 48
SAVE A SERVICE CALL
19
FAN CONTINUES TO RUN AFTER WATER HEATER OPERATION STOPS
It is the normal operation of the water heater for the fan to continue running after heating of the water is finished.
The fan may run for up to two minutes after the burners extinguish, to prepare for the next ignition.
CLOUDS OF WHITE ‘VAPOUR’ FROM THE FLUE TERMINAL
During the heating cycle, it is not unusual to see water vapour clouds
steaming from the flue terminal, particularly on cold days. This is normal
operation of the water heater.
PRESSURE RELIEF VALVE DISCHARGING
A pressure relief valve is incorporated into the water heater controls.
This valve protects the water heater, by allowing water to escape, in the
event of excessive pressure build-up in the waterways.
• Normal operation
A small volume of water may discharge from the bottom of the water
heater when a hot tap is suddenly closed.
• Continuous dribble
A continuous dribble may indicate the water supply pressure is
above the design pressure for the water heater. If so, a pressure
limiting valve must be installed on the cold water supply pipe to the
water heater (refer to “Mains Water Supply” on page 23).
ERROR CODE
The water heater provides a diagnostic error code in the event of an interruption to its operation. The error
code is displayed on the controller(s) (if installed) and on the LED display on the front of the water heater as a
numerical value. If an error code appears:
• Close the hot tap, turn off the controller(s) and switch off the
electrical supply to the water heater.
• Check the gas isolation valve at the gas inlet to the water heater is
fully open.
• Wait 5 minutes, then switch on the electrical supply to the water
heater, turn on a controller and open a hot tap.
If the error code persists, take note of the numerical code, turn off the
hot tap and turn off the controller(s). Phone Rheem Service or their
nearest Accredited Service Agent to arrange for an inspection.
HIGHER THAN EXPECTED GAS BILLS
Should you at any time, feel your gas bill is higher than expected, we
suggest you check the following points:
• Is one outlet (especially the shower) using more hot water than you
think?
Carefully review the family’s hot water usage. Inexpensive flow
control valves can be easily fitted to the shower outlets to reduce
water usage.
• Is the in-series gas booster operating too frequently?
Refer to “Gas Booster Operating Too Frequently” on page 18.
• Has there been an increase in hot water usage?
An increase in hot water usage will result in an increase in water heater operation.
• Has your water heating tariff rate been increased by your gas retailer since your previous bill?
IF YOU HAVE CHECKED ALL THE FOREGOING AND STILL BELIEVE YOU NEED ASSISTANCE, PHONE
RHEEM SERVICE OR THEIR NEAREST ACCREDITED SERVICE AGENT.
Bekijk gratis de handleiding van Rheem 876A26PF, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rheem |
| Model | 876A26PF |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7567 MB |