Handleiding
Je bekijkt pagina 35 van 70
TRANSPORT AND STORAGE
Transport and store the device in its original protective packaging it against mechanical damage, moisture and dust.
ATTENTION! Do not move the kitchen by holding the oven handle
INSTRUCTIONS FOR THE INSTALLER
Connecting and adapting the device to the appropriate type of gas can be performed by a gas equipment installer
with appropriate qualifications only, in accordance with applicable regulations.
After carrying out the above-mentioned activities, the installer should indicate in the TECHNICAL DATA table in the
warranty card the type of gas for which the appliance has been adapted.
The manufacturer is not liable for damage resulting from failure to comply with applicable standards and
regulations or connecting the device by an unauthorized person!
Remove the packaging and place the appliance in a dry, well-ventilated room. away from curtains. Do not store
paper, alcohol, gasoline, etc. near the appliance.
The connection must be made in accordance with applicable standards and regulations!
The appliance is adapted to be powered by gas with the parameters specified on the rating plate. Check whether the
given gas characteristics correspond to the parameters of the feed gas.
The appliance is equipped with a pipe connector with a G½" thread. Connect the gas to the spigot using appropriate
accessories.
The appliance can be connected to the internal home installation or to a liquefied gas cylinder.
Before starting the connection, the gas tap must be closed.
CONNECTION BY FLEXIBLE HOSE
ATTENTION!
Connection using a flexible hose can only be made after checking whether it’is compatible with applicable
regulations.
ATTENTION!
The appliance can be connected to gas on the right or left side. Screw the cap (4) onto the unused supply pipe -
After connecting the appliance to the gas installation, check whether gas is leaking from under the cap.
1. Natural gas connection
The appliance can be connected to the gas installation "rigidly" or using a certified flexible metal hose.
The maximum length of the flexible hose should not exceed 2.0 m.
The hose should not come into contact with any moving parts and should not pass through a space where there is
not enough space.
When connecting to a rigid piping system, take care to not cause stress at any point in the installation or in any part
of the device.
At the end of installation, perform a gas leak test using a soapy solution.
1. Nipple G1/2
2. Silicone gasket
3. G1/2 gas hose (compliant with EN 14800
Bekijk gratis de handleiding van Ravanson KWGE-K550, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ravanson |
| Model | KWGE-K550 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 10955 MB |