Rane AC 23S handleiding
Handleiding
Je bekijkt pagina 6 van 18
Manual-3
REAR PANEL: STEREO 2-WAY CONNECTIONS
Observe the labels above the Inputs and Outputs for Stereo operation.
1 CHANNEL 1 INPUT: Plug the left output of the mixer, equalizer or other signal source to this Input. Pin 2 is “hot” per AES
standards.
2 CHANNEL 2 INPUT: Plug the right output of the mixer, equalizer or other signal source to this Input.
3 HIGH FREQUENCY OUTPUTS: Connect the CHANNEL 1 HIGH OUT to the left channel input of the high frequency
amp, and the CHANNEL 2 HIGH OUT to the right channel input of the high frequency amp.
4 LOW FREQUENCY OUTPUTS: Connect the CHANNEL 1 “2W-LOW” Output to the left channel input of the low frequen-
cy amplifier, and the CHANNEL 2 “2W-LOW” Output to the right channel input of the low amplifier. If you need a summed
Mono Low Ouput, see ‘Monoing the Low Outputs’ on page Manual-15.
5 STEREO / MONO switch: Set this switch to the STEREO “out” position.
6 STEREO 2‑Way / 3‑Way switches: Slide the switches to the 2-Way position. is switch removes the Low frequency crossover
from the signal path. Low frequencies are now routed to the Mid frequency Output. Note: e Low frequency outputs are still active
and may be used as additional Low outputs.
7 MONO 4‑Way / 5‑Way switch: Set this switch to the 5-Way position for stereo operation.
8 Universal Voltage Input: via a miniature IEC 60320 C6 appliance inlet. is mates with an IEC 60320 C5 line cord (USA
domestic). Do not lift the ground connection!
5W: HIGH MID OUT LOW OUTHIGH OUT
4W: OMIT
MONO: OMIT
3W: LOW OUT
2W: OMIT
3W: MID OUT
2W: LOW
HIGH OUT
3W 2W
CHANNEL 2
STEREO
CHANNEL 1
STEREO
MONO 4W / 5W IN
MONO: OMIT
SUB OUT MID OUT
3W: LOW OUT
2W: OMIT
3W: MID OUT
2W: LOW
3W 2W
MONO
4W 5W
STEREO
STEREO 3W / 2W HIGH OUT
PIN 2: POSITIVE
PIN 3: NEGATIVE
PIN 1: CHASSIS GND
CHANNEL 2 IN CHANNEL 1 IN
MONO: SET SWITCHES AS SHOWN
100-240 V
50/60 Hz 7 WATTS
COMMERCIAL AUDIO
EQUIPMENT 24TJ
R
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
ACN 001 345 482
RANE CORP.
AC 23S
SET TO
5W
1
Left Input
2
Right Input
6 5 67
8
Low Amp
4
High Amp
3
Low Amp
4
High Amp
3
Stereo 2-way connection labels are in this row
Bekijk gratis de handleiding van Rane AC 23S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rane |
| Model | AC 23S |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3571 MB |
