Radial Engineering Workhorse Shuttle handleiding
Handleiding
Je bekijkt pagina 7 van 12
True to the Music
®
Radial Engineering Ltd.
Shuttle™ 500 Module
5
Unbalanced Patch Point
For those equipped with a Workhorse 500 series rack, a second loop is available via front
panel ¼” unbalanced SEND and RECEIVE jacks. The most common method of routing
effects in the studio is via an unbalanced effects insert. This of course is common to all
recording consoles, but is not always convenient with today’s digital recording workstations.
The Shuttle brings the convenience of front panel patching to your Workhorse.
Connect the source signal to the Shuttle via the Workhorse and the signal will automatically
be routed to the LOOP-2 front panel ¼” connectors. The Shuttle is equipped with internal
buffers that will properly unbalance the signal so that your effect device will get the proper
level and impedance. Use standard guitar type ¼” cables to route the signal to and from your
effect device. Once the signal is received back into the Shuttle it is routed to the internal mix
buss and the Workhorse mixer section. The front panel on-off switch lets you bypass the loop
so you can compare the wet and dry signals.
UNBALANCED PATCH POINT USED
IN THE RADIAL WORKHORSE RACK
ON
ON
MONO
2
3
41
LEVEL
CLIP
PAN
Made in Canada
LEVEL
ON
6
78
5
LEVEL
MAIN
MON
48V PHANTOM
+16V / -16V
LEVEL
CLIP
PAN
ON
LEVEL
CLIP
PAN
ON
LEVEL
CLIP
PAN
PAN PANPANPA N
ON
LEVEL
CLIP
LEVEL
ON
LEVEL
CLIPON
LEVEL
CLIPON
LEVEL
CLIPON
MIX BUSS
WORKHORSE MIXER
Tip
Tip
Sleeve
Sleeve
Shield
Tip
Sleeve
Sleeve
Tip
¼” PHONE to ¼” PHONE UNBALANCED WIRE DIAGRAM
Bekijk gratis de handleiding van Radial Engineering Workhorse Shuttle, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Radial Engineering |
| Model | Workhorse Shuttle |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1828 MB |
