Radial Engineering Tossover handleiding
Handleiding
Je bekijkt pagina 4 van 11
Tossover™ 500 Series Module
True to the Music
®
Radial Engineering Ltd.
2
FEATURE SET
1
5
2
6
3
7
4
8
9
10
11
1. HPF FREQUENCY: Used to adjust the high
frequency cut-off point above which the signal will
be allowed to pass.
2. HPF SLOPE: Three position switch sets the
crossover slope for 12dB, 18dB or 24dB per
octave for soft, medium and increased fi lter effect.
3. HPF AMPLITUDE: Used to adjust the output level
of the signal after it passes through the high pass
fi lter. Controls output level for both fi lters when
used in series mode.
4. HPF ON: Turns on the high pass fi lter section. An
LED will illuminate when the fi lter is active.
5. LPF FREQUENCY: Used to adjust the low
frequency cut-off point below which the signal will
be allowed to pass.
6. LPF SLOPE: Three position switch sets the
crossover slope for 12dB, 18dB or 24dB per
octave for soft, medium and increased fi lter effect.
7. LPF AMPLITUDE: Used to adjust the output level
of the signal after it passes through the low pass
fi lter. It is disabled when used in series mode.
8. LPF ON: Turns on the low pass fi lter section. An
LED will illuminate when the fi lter is active.
9. BOTH (BAND PASS): Combines the two fi lters in
series to create a band-pass fi lter.
10. OMNIPORT: ¼” TRS connector (found on Radial
Workhorse power racks) is the alternate output
for 2-way mode.
11. OUTPUT SELECT: Mini-toggle switch near the
15-pin card edge selects which of the two fi lters
will be routed to the XLR or the Omniport when
using the Tossover with a Radial 500 series rack.
Bekijk gratis de handleiding van Radial Engineering Tossover, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Radial Engineering |
| Model | Tossover |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2042 MB |
