QSC unDNEMO-BT handleiding
Handleiding
Je bekijkt pagina 11 van 25
unDNEMO/unDNEMO-BT
User Manual
Attero Tech LLC 2020 Page 10 614-00032
2.4 – Net Mode
The primary operating mode for Dante® audio monitoring applications
is the Net mode. In this mode, Dante® audio channels are selected by
the user from the front panel controls for simple and efficient audio
monitoring applications.
Both the unDNEMO and unDNEMO-BT support 64 audio channels that
can be configured for monitoring. Each channel can be allocated an
audio channel from the Dante® network. Additionally, the installer has
the option of configuring the Net mode to implement stereo
monitoring. If stereo monitoring is enabled, then the maximum number
of channels available to the end user is 32, as a single stereo channel
consists of two mono channels, each of which are allocated a Dante®
audio channel. The mono/stereo configuration is shown in the upper
right of the display accordingly.
Use the channel up/down buttons to cycle through the available
channels. Only channels that have had a Dante® channel assigned and
have been enabled within the unIFY Control Panel software will be
selectable. When selected, a subscription to the configured Dante®
audio channel will be made as quickly as possible and that audio should
then be heard through the internal speaker, connected headphones or
Bluetooth® output device (NEMO-BT only).
When an audio subscription is made, the selected mono channel will be
mapped to both the left and right headphone outputs, left and right
Bluetooth® outputs (unDNEMO-BT only), and to the internal speaker. If
the stereo monitoring mode is enabled, the left and right stereo signals
will be mapped respectively to the stereo headphones and Bluetooth®
outputs (unDNEMO-BT only) and a mono sum of the stereo signal will
be routed to the internal speaker.
For each channel, the display indicates the slot number that has been
assigned in the top area of the display and the associated channel name
in the central viewing area. If a configured Dante® channel is selected
but not available on the audio network for any reason, the screen will
toggle between the channel name and the warning message “Channel
Unavailable”.
*NOTE: By default, the unDNEMO and unDNEMO-BT are not configured with any channel assignments and these must be configured
before first use.
In this mode if the “Dante TX” is mode is enabled, audio is also available on the Dante® network from one of the unDNEMO or
unDNEMO-BT’s audio inputs. The transmit source is selected via in the Net TX menu (See Section 2.9.5 – Menu Mode: Net TX
Source). As notes
Figure 8 – Net Mode Internal Audio Flow w/ Dante® TX
Figure 6 - Net Mode Screen
Figure 7 – Net Mode Internal Audio Flow w/o
Dante® TX
Bekijk gratis de handleiding van QSC unDNEMO-BT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | QSC |
| Model | unDNEMO-BT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4700 MB |
