QSC unD4I-L handleiding
Handleiding
Je bekijkt pagina 7 van 19
Attero Tech by QSC unD4I-L
User Manual
QSC, LLC 2020 614-00025
2.1 – Mounting
Installation of the unD4I-L is very straight forward. It is recommended that the unit be secured to a flat surface with a
screw through each mounting flange. Dimensions for mounting are show in the Figure 2 below. Use a No. 6 screw of a
type and size that is applicable to the surface to which the device will be attached.
Figure 2 - Mounting Information
All connections should be made before the power is applied.
o Attach any audio sources that will be used to the inputs. The inputs are balanced so be sure to check what
output type the source to be connected uses in order to find how to connect it correctly (see Hardware
Connections section).
o Attach any logic devices to the logic inputs and/or logic outputs.
*Note: All Attero Tech products are tested using UTP cabling and it is recommended that UTP cabling be used when
installing them. STP cabling can be used for installation though care must be taken not introduce grounding issues into
the system by doing so.
When powering using PoE:
o Attach the PoE + Data Dante I/F port to a spare PoE-enabled port on a PoE switch using a CAT-5 cable. If a
midspan injector is being used, connect a spare input port to the Dante network switch using a CAT-5 cable,
and then connect the corresponding output port to the PoE + Data Dante I/F of the unD4I-L.
*Note: Using the “Data only” port connected to a PoE-enabled port on a PoE switch will not power the unit.
When powering using an optional external supply:
o Attach either Dante I/F port to a spare port on the Dante network switch using a CAT-5 cable.
o Attach the power supply to the power input jack and then power up the external supply.
If all steps are performed correctly, the power light on the front should be lit. There may also be some activity on the
Dante I/F LED indicators. With no Dante network, both LEDs will remain off. If an active connection is made both LEDs will
come on and if there is network activity, the yellow LED will then flash.
Bekijk gratis de handleiding van QSC unD4I-L, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | QSC |
| Model | unD4I-L |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2811 MB |
