Proficare PC-BS 3133 handleiding
Handleiding
Je bekijkt pagina 9 van 46
PC-BS3133_IM_10.2024 24.10.24
9
Notes for Use
• Dirty filters reduce the suction power of the appliance,
therefore we recommend cleaning the dust container
and the lters after each use.
• You can attach the nozzle attachments directly to the
connection on the appliance or to the suction tube that is
already mounted.
• To detach the nozzle attachments, pull them off with a
slight twist.
Floor Nozzle
You can clean smooth surfaces and carpets with the floor
nozzle. It is equipped with rollers to make it easier to guide.
• With the lever, you can move the brushes outwards or
inwards.
The optimal use depends on the condition of the floor. We
recommend the following use:
- Use without brushes:
For vacuuming carpeted floors.
- Use with brushes:
For vacuuming smooth floors.
Hard Floor Brush
For gentle cleaning of hard floors such as parquet, laminate,
tiles, etc.
Combined Crevice Nozzle and Brush Nozzle
When folded, you can use this as a crevice nozzle. If you
want to use the brush nozzle, pull the brush part in the
direction of the arrow until it engages mechanically.
- Crevice Nozzle:
Use this to vacuum dirt from corners, joints and small
gaps.
- Brush Nozzle:
Gently removes dirt from slits in upholstery and mat-
tresses. Also suitable for picking up dust on sensitive
surfaces such as furniture or curtains.
Telescopic Suction Tube
You can adjust the length of the telescopic suction tube
individually:
1. Attach the telescopic suction tube to the connection on
the appliance by turning it slightly.
2. Release the lock by pushing and holding the slider (12)
in the direction of the arrow.
3. Pull one tube out of the other to the desired length.
4. Release the button to lock the connection.
5. Fit the floor nozzle or accessories.
Electrical Connection
• Before inserting the mains plug into the socket, check
that the mains voltage is correct. You will nd the details
of the appliance on the type plate.
• Only connect the appliance to an approved socket.
Switching the Appliance On / Off
• The appliance is switched off when the switch is in the
O position.
• Set the switch to position I to switch on the appliance.
Mounting the Wall Bracket
CAUTION:
Make sure beforehand that there are no hidden cables in
the wall that could damage you!
1. Measure the height for the wall bracket. Hold the
appliance against the wall when it is mounted with the
telescopic suction tube and oor nozzle.
2. Hold the wall bracket against the wall so that the opening
points upwards. Mark 3 holes.
3. Drill the holes and place the plugs in the wall.
4. Insert the screws through the holes in the wall bracket.
Screw the screws into the plugs.
5. Hand-tighten the screws with a suitable screwdriver.
Operation
1. Unwind the mains cable completely.
2. Insert the mains plug into a properly installed protective
contact socket.
3. Switch the appliance on with the on / off switch.
4. Tilt the lever to “brushes extended” or “brushes retracted”
depending on the oor covering.
5. Now vacuum with even speed. It is not necessary to
press down.
- Be aware of the limited range due to the length of the
cable!
End Operation
1. Switch off the appliance. Then pull the mains plug out of
the socket.
2. Let the appliance cool down completely.
3. If you have previously mounted the wall bracket, hang
the appliance in it.
4. Loosely roll up the mains cable. You can use the hook-
and-loop tape on the mains cable to secure the cable.
Bekijk gratis de handleiding van Proficare PC-BS 3133, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Proficare |
| Model | PC-BS 3133 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 6259 MB |
