Pro1 T725 handleiding
Handleiding
Je bekijkt pagina 1 van 4

T725
Installation Manual
Pro1 Technologies
Toll Free: 888-776-1427 
Web: www.pro1iaq.com
Hours of Operation: M-F 9AM - 6PM Eastern 
Power Type
Battery Power
Hardwire (Common Wire)
Hardwire (Common Wire) with 
Battery Backup
A trained, experienced 
technician must install this 
product.
Carefully read these 
instructions.  You could damage 
this product or cause a 
hazardous condition if you fail to 
follow these instructions.
Una version en español de este 
manual se puede descargar en 
la pagina web de la compañia.
Rev. 1751
     U.S. Registered Trademark. Patents pending
Copyright      2017 All Rights Reserved.
Installation Tips
Installation Tips
Thermostat Application Guide
Table of Contents
Installation Tips
Thermostat Quick Reference
Wiring
Wiring Diagrams
Features & About The Badge
Technician Setup
Programming Thermostat
Page
2-3 
4-5
6 
7
8
13-16
Subbase Installation
The thermostat should be installed approximately 4 to 5 feet above the 
oor.  Select an area with average temperature and good air circulation.
•  Close to hot or cold air ducts
•  That are in direct sunlight
•  With an outside wall behind 
   the thermostat
•  In areas that do not require 
   conditioning
•  Where there are dead spots 
   or drafts 
   (in corners or behind doors)
•  Where there might be 
   concealed chimneys or
   pipes
Wall Locations
Vertical Mount
Horizontal Mount
For vertical mount put one screw on the top 
and one screw on the bottom.
For horizontal mount put one screw on the 
left and one screw on the right.
All of our products are mercury free. 
However, if the product you are 
replacing contains mercury, dispose of 
it properly.  Your local waste 
management authority can give you 
instructions on recycling and proper 
disposal.
Pick an installation location that is easy for 
the user to access.  The temperature of the 
location should be representative of the 
building.
Installation Tip
Mercury Notice
Do not install 
thermostat in locations:
Failure to disconnect the power before 
beginning to install this product can 
cause electrical shock or equipment 
damage.
Installation Tip: 
Electrical Hazard
Mount Thermostat
Align the 4 tabs on the subbase with 
corresponding slots on the back of the 
thermostat, then push gently until the 
thermostat snaps in place.
Battery Installation
Battery installation is recommended even if thermostat is hardwired 
(C terminal connected).  When thermostat is hardwired and batteries 
are installed, the thermostat will activate a compressor delay of 5 
minutes when the thermostat detects a power outage from the 
hardwired power supply.
Important:
High quality alkaline batteries are recommended. 
Rechargeable batteries or low quality batteries 
do not guarantee a 1-year life span.
Insert 2 AA 
Alkaline batteries 
(included). High 
quality alkaline 
batteries are 
recommended.
Simple 
operating 
instructions
are found 
on the back 
of the 
battery 
door.
Getting to know your thermostat
Glow in the dark light button
Fan Switch
System Switch
Easy change battery door
Temperature Setpoint Buttons
LCD Display
Thermostat Quick Reference
Specications
The display range of temperature ... 41˚F to 95˚F (5˚C to 35˚C)
The control range of temperature.... 44˚F to 90˚F (7˚C to 32˚C)
Swing (cycle rate or dierential) ...... Heating is adjustable from 0.2˚ to 2.0˚
                                                                         Cooling is adjustable from 0.2˚ to 2.0˚
Power source ...........................................18 to 30 VAC, NEC Class II, 50/60 Hz 
                                                                      for hardwire
                                                                      Battery power from 2 AA Alkaline 
                                                                      batteries
Operating ambient ............................... 32˚F to +105˚F (0˚C to +41˚C)
Operating humidity .............................. 90% non-condensing maximum
Dimensions of thermostat ................. 4.7”W x 4.4”H x 0.8”D
9 -12
Description
Gas or Oil Heat
Electric Furnace
Heat Pump (No Aux. or Emergency Heat)
Heat Pump (With Aux. or Emergency Heat)
Multi-Stage Systems
Heat Only Systems
Heat Only Systems - Floor or Wall Furnace
Cool Only Systems
Millivolt Conventional Systems
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Two Transformer Systems No
FAN
ON    AUTO
EmHCOOL
OFF HEAT
FAN
ON    AUTO
EmHCOOL
OFF HEAT
P.O. Box 3377
Springeld, MO 65808-3377
Bekijk gratis de handleiding van Pro1 T725, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Pro1 | 
| Model | T725 | 
| Categorie | Niet gecategoriseerd | 
| Taal | Nederlands | 
| Grootte | 1055 MB | 
