Prebena 8XR-CNW90 handleiding
Handleiding
Je bekijkt pagina 29 van 60
29
Please pay special attention to Section 1 – Special Remarks – of
these operating instructions.
Once you have verified that the tool is in optimal operating order,
set the muzzle against the work surface and activate the trigger.
Warning: When driving in fasteners, especially in hard wood or
when using longer fasteners, the tool may recoil. In the case of
tackers with contact triggers (see 1.7), unintentionally setting the
tacker against the work surface may cause it to eject another fas-
tener when you do not want this. For this reason, always hold the
tacker well away from the work surface and set it on the surface only when you
wish to drive another fastener.
Verify that the fastener was driven in according to your specifications.
If the fastener is sticking out, increase the air pressure in 0. 5 bar increments
(do not exceed maximum pressure) until the proper depth is obtained.
If the fastener was driven in too far, reduce the air pressure in 0. 5 bar incre-
ments until the fastener is driven in satisfactorily.
In all cases, try to work with the lowest required pressure. This has three essen-
tial advantages for you:
1. Energy savings.
2. Noise levels are kept to a minimum.
3. Tool wear is kept to a minimum.
Avoid pulling the trigger when the magazine is empty. Disconnect the tool
immediately from the air supply if it is defective or not in optimal working order
and bring it to a competent repair person.
Disconnect the tacker from the air supply and if possible empty the magazine
during longer work breaks and at the end of the day.
Protect the air connections on the tacker and the air hoses from dirt.
If sawdust, shavings, sand etc. get into the tacker, this can lead to breaks in
the seal and will eventually damage the tacker and the hook-ups.
ENGLISH
5. Tool Use
Bekijk gratis de handleiding van Prebena 8XR-CNW90, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Prebena |
| Model | 8XR-CNW90 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5198 MB |
