Prebena 8XR-CNW90 handleiding
Handleiding
Je bekijkt pagina 28 van 60
28
With side-loading systems (A), release the safety catch and pull the side slide bar
back.
Point the tool at an angle towards the ground and insert the nail strips so that
the head slips into the corresponding groove and the tip lies as close to the
magazine bottom as possible.
With the coil nailer system (B), push down the hook and open the
ap.
Open the magazine lid. Verify that the nail plate is properly adjust-
ed for the nail length being used. To adjust the plate, push lightly
on the middle knob and turn counter-clockwise to raise it. Repeat
if necessary. To lower the plate, push down the middle knob lightly and turn
clockwise. Repeat if necessary.
Insert the roll in the magazine and pull the rst nail into the front of the tool with
the heads in the head guide grooves and the two wires in their respective
grooves. Secure the rst nail between the teeth of the feed mechanism. Close
the magazine lid and check to see if the plastic tooth is pushing into the side
wall of the feed mechanism. Make sure that the ap is locked
into position! If
you do not check for this, the nailer could jam or the lid could open when work-
ing in vertical positions or above your head.
The trigger must never be activated during loading and the muzzle of the tool
must never be pointed at yourself or at another person.
PREBENA-Pneumatic staplers and nailers
(A)
(B)
Bekijk gratis de handleiding van Prebena 8XR-CNW90, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Prebena |
| Model | 8XR-CNW90 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5198 MB |
