Practixx PX-AB-55 handleiding
Handleiding
Je bekijkt pagina 24 van 40
w ww.practixx.com
24
|
GB
Carbon brushes
• If excessive sparks are generated, have an elec-
trician check the carbon brushes. Attention! The
carbon brushes must only be replaced by an elec-
trician.
Check that there is enough grease in the product
before putting it into operation. To do this, open the
grease ller opening (8) with the enclosed mainte-
nance tool (D). If there is grease, there is no need to
rell. If no grease is visible, please add grease imme-
diately. To push the grease carefully into the grease
ller opening (8), use the screw of the grease ller
opening (8). Do not use a grease gun. We recommend
the following grease: Mobil SHC220 or Shell S5V100.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*:Carbon brushes, chisel
* may not be included in the scope of supply!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
Ordering spare parts
Please provide the following information when ordering
replacement parts (via the service-hotline):
• Device type
• Device article number (see packaging or instruction
manual)
12. Cleaning
12.1 Cleaning
Keep protective devices, air vents and the motor hous-
ing as free of dust and dirt as possible. We recommend
cleaning the device directly after every use.
12.1.1 Exterior cleaning
• Clean the device at regular intervals using a damp
cloth and a little soft soap.
• Do not use cleaning agents or solvents. These could
damage the plastic parts of the device.
• Make sure that no water can penetrate the device
interior.
AC motor
• The mains voltage must be 230-240 V~.
• Extension cables up to 25 m long must have a
cross-section of 1.5 square millimetres.
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
• The product meets the requirements of
EN 61000-3-11 and is subject to special connection
conditions. This means that use of the product at any
freely selectable connection point is not allowed.
• Given unfavourable conditions in the power supply
the product can cause the voltage to uctuate tem-
porarily.
• The product is intended solely for use at connection
points that
a) do not exceed a maximum permitted supply im-
pedance “Z” (Zmax = 0.434 Ω), or
b) have a continuous current-carrying capacity of
the mains of at least 100 A per phase.
• As the user, you are required to ensure, in consulta-
tion with your electric power company if necessary,
that the connection point at which you wish to oper-
ate the product meets one of the two requirements,
a) or b), named above.
Please provide the following information in the event
of any enquiries:
• Data of machine type plate
11. Maintenance
m Warning! Pull out the mains plug before carrying
out any adjustments, maintenance or repair work!
General maintenance tasks
• Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub
the device clean with a clean cloth or blow it o with
compressed air at low pressure.
• We recommend that you clean the device directly
after every use.
• Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the device. Make sure that no water can
penetrate the device interior.
• All moving parts must be re-lubricated periodically!
Bekijk gratis de handleiding van Practixx PX-AB-55, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Practixx |
| Model | PX-AB-55 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5390 MB |
