PowerWalker Solar Inverter 5000 ZRO Handleiding (84 Pagina's)

Handleiding

8

PV Connection

CAUTION: Before connecting to PV modules, please install separately a DC circuit breaker between inverter

and PV modules.

WARNING! All wiring must be performed by a qualified personnel.

WARNING! It'’ very important for system safety and efficient operation to use appropriate cable for PV module

connection. To reduce risk of injury, please use the proper recommended cable size as below.

WARNING! Never connect the positive and negative terminals of the solar panel to the ground.

Model Typical Amperage Cable Size Torque

5KW/6KW 27A 10 AWG 1.2~1.6 Nm

PV Module Selection:

When selecting proper PV modules, please be sure to consider below parameters:

1. Open circuit Voltage (Voc) of PV modules not exceeds max. PV array open circuit voltage of inverter.

2. Open circuit Voltage (Voc) of PV modules should be higher than min. battery voltage.

Solar Charging Mode

INVERTER MODEL 5KW/6KW

Max. PV Array Open Circuit Voltage

500Vdc

PV Array MPPT Voltage Range

120~430Vdc

Please follow below steps to implement PV module connection:

1. Remove insulation sleeve 10 mm for positive and negative conductors.

2. Check correct polarity of connection cable from PV modules and PV input

connectors. Then, connect positive pole (+) of connection cable to positive

pole (+) of PV input connector. Connect negative pole (-) of connection

cable to negative pole (-) of PV input connector.

3. Make sure the wires are securely connected.

Bekijk gratis de handleiding van PowerWalker Solar Inverter 5000 ZRO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.