Handleiding
Je bekijkt pagina 9 van 53
8
Memory function
When restarting the heater after shut down it will start up on the setting
it was in prior to shut down.
O screen function
While in operation the screen will change after one minute to display only
the heating logo.While holding the "+" and "-" button for 2 seconds, you
can turn o the screen function, once again hold the "+" and "-" button for
2 seconds, turn on the screen function.
Temperature sensor short circuit, open circuit protection function
During operation, when the indoor temperature reaches above 50 degrees,
it will perform safety protection, close all load output (heating element,
etc.), display FF with flash, protection can only stop after power is o.
Safety protection
When the temperature sensor is short circuit or open circuit, it will display
E1 or E2 with flash in any modes, meanwhile, the buttons will not work
and buzzer will ring for 10 times.
ECO energy saving function
ECO energy saving mode: To save energy, it will automatically adjust the
appropriate heating level by comparing the ambient temperature with the
selecting temperature.
Remote controller
Use of the remote controller: the key functions are basically the same as
the body operation panel.
Bekijk gratis de handleiding van Point POHF4020, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Point |
| Model | POHF4020 |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 2949 MB |
