Planet LS100-CO handleiding
Handleiding
Je bekijkt pagina 22 van 45
22
Sensor Measurement
Info
Tilt Sensor
- Conversion Angle: 45° ± 5°
-ContactResistance:Lessthan10Ω
-TheInsulationResistance:Greaterthan100MΩ
- Operating Temperature: -40 °C to 85 °C
- Installation Type: Suitable for PCB at vertical state
Vibration Sensor
- Model: Ball type omnidirectional signal trigger switch
- Voltage: < 6 V
-Current:2μAto10mA
- Insulation Resistance: > 10MΩ
- Trigger Rate: 100% (amplitude > 1 mm, frequency > 20 Hz)
- Trigger Frequency: > 50 Hz
Reed Switch Sensor
- Minimum Insulation Resistance 10
10
Ω
-MaximumContactResistance100mΩ
- Maximum Switching Current 0.5 A
Glass Break Sensor
- Detection Mode: Piezoelectric buzzer
- Power Supply: Self-generated voltage chip
-Impedance:Normal(NC):7Ω(max)Alarm(NO):1MΩ(min)
- Sensor Sensing Range: within 2.5 M radius
- Signal Sensing Time: 1 to 3 seconds
- Loop Voltage: 15 V DC (max)
- Loop Current: 25 mA (max)
- Applicable Glass Type: In theory, as long as any glass is
impacted by high frequency, its vibration frequency and
amplitude can be detected to a certain extent.
- Operating Temperature: -10 to 50 °C
- Wire Length: 100 cm
- Installation: The glass at the installation position must be wiped
cleanrst,andthenthedouble-sidedadhesivetapeonthe
backofthedetectormustbetornandxedontheglass.The
detector should be installed about 10 cm from the corner of the
glass frame.
Ingress Protection
IP30
reed switch - IP67
glass break - IP40
Operating Temperature -10 °C to 50 °C
Relative Humidity < 90 % RH (non-condensing)
Storage Temperature -40 °C to 85 °C
Standards Conformance
Regulatory Compliance CE RED, FCC PART 15B
Bekijk gratis de handleiding van Planet LS100-CO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Planet |
| Model | LS100-CO |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7120 MB |
