Physa PHY-ND-3 handleiding
Handleiding
Je bekijkt pagina 14 van 153
EN
Please check periodically the carbon brush wear to prevent severe damage. The motor can be
damaged if a worn-out carbon brush is not changed in due time.
A – Carbon part
B – Terminal
C – Carbon brushes
1 Unscrew the carbon bolt. The terminal is separated at the same time.
2 Change carbon brushes.
1. Unscrew the bolt 130-23 and unscrew 130-13 fixed in the carbon brush.
2 Remove the soldered carbon and change the new one.
CHANGE COLLET CHUCK
A – Wrench
1 Open the chuck and remove the Dur.
2 Fix the wrench to chuck and turn it to the counterclockwise.
Caution!
Lock the handle properly.
If the handle is turned continuously with pressure the handle and motor part may be disassembled.
Do not dismantle unless you are a qualified engineer. It may cause the breakage.
For replacing the ball bearings, fix the wrench on the nose tip and then turn the handle to the "open"
direction.
Turn the wrench and loosen the nose tip slightly. Turn the handle again to the "close" direction.
Bekijk gratis de handleiding van Physa PHY-ND-3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Physa |
| Model | PHY-ND-3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 24257 MB |
