Physa PHY-ND-3 handleiding
Handleiding
Je bekijkt pagina 12 van 153
EN
When locked in the chuck, the maximum projection length should be less than 35mm. Use
a bur that conforms to the ISO standards.
Avoid using a rusty or bent bur that may cause excessive wear of bearings. Keep a safe speed, and
precautions recommended by bur manufacturer.
5 Check for any troubles, including vibration of bur, at low speed, and then start high speed
6 Operate the speed control dial in the control box softly.
7 Use a fuse of 230V/2A for control box.
8 Turn off the power to change the bur.
9 Be careful not to drop the handpiece as this could damage or break it.
In case it is dropped, check if the bur is bent or if any excessive heat is generated while carefully
operating it.
10 If any problem occurs in the handpiece, only use it again after repairing.
11 Do not turn on the power of the control box while the collet chuck of the handpiece is open.
(Short circuit of the motor may be caused)
12 Make sure that the switch is off before putting the power plug in the socket, to avoid an
unexpected injury due to sudden start.
13 A circuit breaker is provided to protect the motor. It is actuated when there is an overload
which the motor cannot stand. Work within a range of load which is not actuated.
14 Do not open the chuck while operating.
15 Keep the handpiece with setting a bur to the collet chuck after operation.
16 Do not put the handpiece down before it stops completely.
17 Be sure to pull out the power cord before moving the control box.
18 Use the specified voltage.
19 Use accessories suitable for this product.
20 For recommended speed in various applications, follow the manufacturer’s instructions.
21 Wear proper protective clothes and equipment, including a dust mask and safety goggles. Use a
proper suction unit and a ventilator.
22 Keep the workplace clean. Debris may cause an accident.
The allowable RPM according to the bur diameter.
Please keep the RPM according to the below diagram to avoid accidents.
The allowable RPM could be different depending on the bur material and type.
CHECK POINT IN CASE OF PROBLEM
Bekijk gratis de handleiding van Physa PHY-ND-3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Physa |
| Model | PHY-ND-3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 24257 MB |
