Phoenix Contact IB IL AO 4/U/0-10-ECO Handleiding (190 Pagina's)

Handleiding

Je bekijkt pagina 132 van 190

IL SYS INST UM E

132 / 188 Phoenix Contact

6452_en_11

Shield connection clamp The shield connection clamp (a in Figure 12-4, detail B) in the shield connection can be

used in various ways depending on the cable cross-section. For thicker cables (e.g., bus

cable), the dip in the clamp must be turned away from the cable (Figure 12-4, detail B).

For thinner cables, the dip in the clamp must be turned towards the cable (Figure 12-4,

detail F).

If you need to change the position of the shield connection clamp, proceed as shown in

Figure 12-4:

• Open the shield connection housing (detail A).

• The shield connection is delivered with the clamp positioned for connecting thicker

cables (detail B).

• Remove the clamp (detail C), turn it to suit the cross-section of the cable (detail D),

then reinsert the clamp (detail E).

• Detail F shows the position of the clamp for a thin cable.

Figure 12-4 Shield connection clamp alignment

12.1.3 Connecting shielded cables using an Inline connector

With analog, function, or communication terminals without Inline shield plug, shielding

can be connected by separate accessories.

The recommended accessories can be found on the item page at

phoenixcontact.com/products

.

A

a

B

C

D

E

F

Bekijk gratis de handleiding van Phoenix Contact IB IL AO 4/U/0-10-ECO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.