Phoenix Contact FL PN/PN SDIO-2TX/2TX handleiding

94 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 37 van 94
Mounting, removal, electrical installation, and replacement
8220_en_06 PHOENIX CONTACT 37
3 Mounting, removal, electrical installation, and
replacement
3.1 General
Only qualified personnel should pack and unpack the FL PN/PN SDIO-2TX/2TX while
observing the following ESD regulations.
WARNING: Loss of electrical safety and the safety function when using unsuitable
power supplies
The FL PN/PN SDIO-2TX/2TX is designed exclusively for protective extra-low voltage
(PELV) operation according to EN 60204-1. Only PELV according to the defined standard
may be used for supply purposes.
The following applies to the network and the I/O devices used in it:
Only use power supply units that meet EN 61204 with safe isolation and PELV according
to EN 50178/VDE 0160 (PELV). This prevents short circuits between primary and
secondary sides.
NOTE: Electrostatic discharge
The device contains components that can be damaged or destroyed by electrostatic
discharge. When handling the device, observe the necessary safety precautions against
electrostatic discharge (ESD) according to EN 61340-5-1.
WARNING: Unintentional machine startup
Do not mount or remove the FL PN/PN SDIO-2TX/2TX while the power is connected.
Before mounting or removing the device, disconnect the power to the device and ensure
that it cannot be switched on again.
Make sure the entire station is reassembled before switching the power back on. Observe
the diagnostic indicators and any diagnostic messages.
The system may only be started provided neither the device nor the system poses a
hazard.
Observe the PROFINET Installation Guideline for Cabling and Assembly
Observe the PROFINET Installation Guideline for Cabling and Assembly when mounting
and installing the FL PN/PN SDIO-2TX/2TX. The guideline can be downloaded at
profinet.com or you can contact your nearest Phoenix Contact representative regarding
this document.

Bekijk gratis de handleiding van Phoenix Contact FL PN/PN SDIO-2TX/2TX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkPhoenix Contact
ModelFL PN/PN SDIO-2TX/2TX
CategorieNiet gecategoriseerd
TaalNederlands
Grootte7175 MB