Phoenix Contact AXC 1050 XC handleiding
Handleiding
Je bekijkt pagina 8 van 68
PHOENIX CONTACT IEDs – IEC 61850
8 / 68
PHOENIX CONTACT 107801_en_00
3 PC Worx or Config+
To use the AXC 1050 (XC) controller or AXL F BK SAS bus coupler as IEDs, you have to
configure certain settings in the PC Worx or Config+ software. Which settings these are ex-
actly, and in which software the settings have to be configured, depend on your bus struc-
ture and the devices that are to be used as IEDs. Table 3-1 shows which software you have
to use.
General requirements: The following is assumed:
– The Axioline F station has been installed, connected and wired.
– There is an Ethernet connection between the IED(s) (AXC 1050 (XC) and/or
AXL F BK SAS) and your PC.
Depending on your bus structure, the following requirements additionally apply:
Bus structure with
AXC 1050 (XC)
If you use at least one AXC 1050 (XC) controller in your bus structure, it is assumed that you
have already taken the following steps in PC Worx:
– Created a project.
– Assigned an IP address to all IEDs contained in the project.
– Imported the bus structure.
– Configured the AXL F BK SAS bus coupler(s), if one or more bus couplers of this type
are present in the bus structure and are to be used as IEDs.
Bus structure
AXL F BK SAS without
AXC 1050 (XC)
If you use one or several AXL F BK SAS bus couplers without AXC 1050 (XC) controllers,
it is assumed that you have done the following:
– Created a project in PC Worx or Config+.
– Assigned an IP address for all IEDs contained in the project.
– Imported the bus structure.
– Configured all AXL F BK SAS bus couplers that are to be used as IEDs.
Table 3-1 Software to be used depending on the IED(s) in the bus structure
IED(s) in the bus structure Software
AXC 1050 (XC) PC Worx ≥ 6.30.1914
1
1
Component of the AUTOMATIONWORX Software Suite 2017 Version 1.84
AXC 1050 (XC) and AXL F BK SAS PC Worx ≥ 6.30.1914
1
AXL F BK SAS without AXC 1050 (XC) PC Worx ≥ 6.30.1914
1
or
Config+ ≥ 1.60.1914
1
For additional information on creating projects in PC Worx, please refer to the user man-
ual of the controller you are using. The user manual can be downloaded at
phoenixcontact.net/products.
The procedure for parameterization is identical in PC Worx and in Config+, and is de-
scribed in Section 3.1.8.
Bekijk gratis de handleiding van Phoenix Contact AXC 1050 XC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Phoenix Contact |
| Model | AXC 1050 XC |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6905 MB |
