Phoenix Contact AS-WORKBENCH-F 90 MA handleiding

Niet gecategoriseerd

Phoenix Contact

52 pagina's

PDF beschikbaar

Handleiding

clipx WIRE assist

28 / 50 Phoenix Contact

109435_en_02

3 Operation and maintenance

3.1 Setting up and moving the workbench

WARNING: Risk of electric shock

Disconnect the mains plug before moving the workbench. Make sure not to damage

the cables.

• Make sure you always set up the workbench on a level and solid surface. The work-

bench is only suitable for use in enclosed spaces.

• Secure the workbench to prevent it from rolling unintentionally. To do this, lock the front

two castors.

3.2 Raising and lowering the work surface

WARNING: Danger of crushing

When moving the workbench up and down, be careful not to trap any part of your body

between the work surface and adjoining parts.

NOTE: If there is an unusual noise or smell coming from the control unit during oper-

ation, disconnect the power supply immediately.

NOTE: The maximum load for the work surface is 65 kg. Do not exceed this limit.

NOTE: Regardless of the weight involved, you must never allow the workbench drive

to run for longer than six minutes per hour or a maximum of two minutes in continuous

operation. After two minutes of continuous operation, the system needs an 18 minute

break. Exceeding the operating time can significantly reduce the service life of the

system, as the motor, brake, and spindle nut will overheat.

Operation

• Secure the workbench to prevent it from rolling unintentionally. To do this, lock the front

two castors.

• Attach the devices to the workbench by appropriate means so that they cannot fall off.

• Raising the workbench: On the control element, press the switch with the up arrow.

• Lowering the workbench: On the control element, press the switch with the down ar-

row.

Bekijk gratis de handleiding van Phoenix Contact AS-WORKBENCH-F 90 MA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.