Philips UltraWide Momentum 345M2RL handleiding

Monitor

Philips

32 pagina's

PDF beschikbaar

Handleiding

9. Troubleshooting & FAQs

9. Troubleshooting &

FAQs

9.1 Troubleshooting

This page deals with problems that can

be corrected by a user. If the problem

still persists after you have tried these

solutions, contact Philips customer service

representative.

Common Problems

No Picture (Power LED not lit)

• Make sure the power cord is plugged

into the power outlet and into the

back of the monitor.

• First, ensure that the power button

on the rear side of the display is in the

OFF position, then press it to the ON

position.

No Picture (Power LED is White)

• Make sure the computer is turned on.

• Make sure the signal cable is properly

connected to your computer.

• Make sure the monitor cable has no

bent pins on the connect side. If yes,

repair or replace the cable.

• The Energy Saving feature may be

activated

Screen says

  

• Make sure the monitor cable is

properly connected to your computer.

(Also refer to the Quick Start Guide).

• Check to see if the monitor cable has

bent pins.

• Make sure the computer is turned on.

Visible signs of smoke or sparks

• Do not perform any troubleshooting

steps

• Disconnect the monitor from mains

power source immediately for safety

• Contact with Philips customer service

representative immediately.

Imaging Problems

Image vibrates on the screen

• Check that the signal cable is properly

securely connected to the graphics

board or PC.

Image appears blurred, indistinct or too

dark

• Adjust the contrast and brightness on

On-Screen Display.

An "after-image", "burn-in" or "ghost

image" remains after the power has

beenturnedo.

• Uninterrupted display of still or static

images over an extended period may

cause "burn-in", also known as "after-

imaging " or "ghost imaging", on your

screen. "Burn-in", "after-imaging",

or "ghost imaging" is a well-known

phenomenon in monitor panel

technology. In most cases, the "burned

in" or "after-imaging" or "ghost

imaging" will disappear gradually over

a period of time after the power has

been switched off.

• Always activate a moving screen saver

program when you leave your monitor

unattended.

• Always activate a periodic screen

refresh application if your monitor will

display unchanging static content.

• Failure to activate a screen saver, or

a periodic screen refresh application

may result in severe “burn-in” or

“after-image” or “ghost image”

symptoms that will not disappear

and cannot be repaired. The damage

Bekijk gratis de handleiding van Philips UltraWide Momentum 345M2RL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.