Philips 7000 Series XW7110 handleiding
Handleiding
Je bekijkt pagina 27 van 605
27
English
Problem Possible cause Solution
Bigger dirt particles are not
sucked up anymore and fall
back on the floor.
The water channel of the wet
module and/or AquaSpin
nozzle is polluted or blocked.
Use the cleaning brush and clean the water
channel of the main body and/or AquaSpin
nozzle (see 'Removing blockages from the
appliance').
The floor dries with stripes. You may have used too much
detergent.
Make sure to use the right amount of
detergent.
The wheels are dirty. Remove the dirt from the wheels.
There is too much foam
while cleaning, but also
during AUTOCLEAN.
You may have used too much
detergent.
Make sure to use the right amount of
detergent.
There are still detergent
residues on the floor.
Clean the floor without detergent several
times. Wait a moment before going over
the same stain again.
It is difficult to clean stains. You may have used too little
water or taken too little time to
clean the stain.
Apply water and wait a moment. For
example you can go with the appliance
over the stain to apply water and come
back to the same stain in the end of the
cleaning session.
The sound of the appliance
changed while cleaning.
There might be hairs or other
obstacles entangled around
the microfiber brushes
Remove the microfiber brushes and check
for obstacles and remove them.
The display indicates that the
dirty water tank is full (code:
i1) and shuts down,
although the dirty water
tank is not full yet.
There may be foam or
contamination of the dirty
water tank.
Restart the appliance. If that does not solve
the problem, clean the dirty water tank. If
foaming is the issue, make sure you do not
use more than the recommended amount
of detergent.
Water drips out of the
appliance after it is switched
off.
The appliance leaves a puddle
on the floor because you did
not move it while switching it
off. This is normal.
The appliance can leave a small puddle of
water on the floor if you do not move the
appliance while switching it off. You can
reduce the size of the puddle by moving
the appliance while switching it off. When
you switch off the appliance, it will switch
to water absorption mode for 4 seconds
to clean up any water remaining in the
nozzle. If needed, you can remove the last
drops with a cloth.
The appliance is dripping when
carrying it over the floor
(holding it in the air).
While cleaning, do not lift the AquaSpin
nozzle from the floor, as this leaves water
traces. Only move forwards and backwards.
It is also recommended to use water
absorption mode when lifting the
appliance over a threshold, carpet or stairs.
This will prevent dirty water from dripping
out of the AquaSpin nozzle.
Bekijk gratis de handleiding van Philips 7000 Series XW7110, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Philips |
| Model | 7000 Series XW7110 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 55616 MB |
