Perfect Aire 2PHG7500 handleiding
Handleiding
Je bekijkt pagina 6 van 12
6
TIMER FUNCTION:
The Timer function allows you to set the length
of operation from 1 to 12 hours. Each time the
TIMER button is pressed the length of operation will
increase 1 hour. The duration the timer is set for will
be displayed on the LED screen in hour increments.
TO TURN THE TIMER FUNCTION OFF:
Press the TIMER Button continuously until the LED
screen displays “O”.
FAHRENHEIT OR CELSIUS DISPLAY:
To switch the display between Fahrenheit and
Celsius, press the °F/°C on either the unit or the
remote.
INSTALLING THE HEATER:
LOCATING THE HEATER:
Install the heater out of trac areas, maintaining
the clearances stated in Figure 1 on page 5. The
air ow from the heater must not be restricted or
obstructed by any items in the room. When more
than one heater is used in an area, the heaters
should be arranged so that the air discharge of
each heater supports the air ow of the others to
provide best circulation of warm air, as indicated
below in Figure 3.
OPERATING INSTRUCTIONS
Figure 3
NOTE: The timer function is not an excuse to
leave the heater unattended.
NOTE: Heater will cycle on and o to maintain
room temperature. The rst time you operate
the unit, it may smoke slightly. This is due to
residual cleaning agents used to clean the
element when the heater is manufactured.
This is normal and does not indicate a problem
with the unit. This condition will stop after the
heater has been in operation for a few minutes.
(Continued)
2. The temperature setting can be adjusted
between 45°F (7°C) to 95°F (35°C). To change
the temperature, press the TEMP+ or TEMP-
buttons on either the unit or the remote. (See
Figure 2)
3. The temperature display will blink while it is
being adjusted.
When the desired temperature is reached, it
will take about 5 seconds to accept the setting.
Once the display stops ashing, the room
temperature will reappear on the LED screen
to indicate the desired temperature is set.
4. In any temperature mode, the unit will stay
in that mode,cycling on and o to maintain the
set temperature. The heater will reach the set
temperature faster in HIGH setting.
5. The heater can be turned OFF by pressing the
POWER button. Once the unit is turned o, the
fan will continue to run to cool down the unit
and there will be a 90 seconds countdown on
the digital display.
Power
Control
Switch
Figure 2
Temperature
Controls +/-
Temperature
Display
Control Panel Detail
(enlarged for clarity)
Thermostat range is 45°F/7°C - 95°F/35°C.
Bekijk gratis de handleiding van Perfect Aire 2PHG7500, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Perfect Aire |
| Model | 2PHG7500 |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 2146 MB |
