Perfect Aire 1PAFP16E handleiding
Handleiding
Je bekijkt pagina 7 van 8
7
Step 10. Thread Blade Cap
onto threaded end
of Motor Shaft.
NOTE: Threads are reversed.
Tighten = Counter‑clockwise
Step 11. With logo upright,
attach Front Grille to
Rear Grille by snapping
them together. Be sure
all 8 clips are secure.
Do not operate fan
without grille in place.
FAN ASSEMBLY
CLEANING
CAUTION Before cleaning the fan be
sure to disconnect power cord from the plug.
Clean the grille surface with a clean damp cloth.
Do not use harsh chemical or abrasive cleaners.
DO NOT IMMERSE THE FAN OR ANY WIRES IN
WATER. Allow fan to dry completely before use.
Periodic grille cleaning with a vacuum will prevent
dust build up. The motor is sealed and does not
require any interior maintenance, cleaning or
lubrication.
MAINTENANCE
The Internal motor bearings are permanently
lubricated at the factory and do not require any
additional lubrication.
REPAIR
DO NOT OPERATE THE FAN WITHOUT THE
GRILLE IN PLACE. DO NOT USE THE FAN IF IT
HAS MALFUNCTIONED OR BECOME DAMAGED
IN ANY WAY.
STORAGE
Keep original carton for storage of the fan. Coil
and tie the power cord to avoid damage during
storage.
NOTE: Some models come with a plug where
you can replace a fuse. If your model has this,
please read and follow the below instructions
to replace the fuse.
Fig. 3
Fig. 2
Slide Cover to Open
Fig. 1
This product employs overload protection (fuse).
A blown fuse indicates an overload or short‑circuit
situation. If the fuse blows, unplug the product
from the outlet. Replace the fuse as per the user
servicing instructions (follow product marking
for proper fuse rating) and check the product. If
the replacement fuse blows, a short‑circuit may
be present and the product should be discarded
or returned to an authorized service facility for
examination and/or repair.
FUSE REPLACEMENT
1. Grasp plug and remove from the receptacle or
other outlet device. Do not unplug by pulling on
cord. See Fig. 1
2. Open fuse cover by sliding open fuse access
cover on top of attachment plug towards
blades. See Fig. 2
3. Remove fuse carefully. Use a small tool to pry
the end of the fuse from holder cavity. Be careful
not to break glass window. See Fig. 3
4. Replace fuse.
WARNING Risk of re.
Replace fuse only with identical 2.5 or 5.0 Amp,
125 Volt fuse (3.6mm x 10mm). Be sure fuse is
properly seated within its cavity.
5. Close fuse cover by sliding it back to its original
closed position. See Fig. 1
(Continued)
Bekijk gratis de handleiding van Perfect Aire 1PAFP16E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Perfect Aire |
| Model | 1PAFP16E |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 1524 MB |
