Handleiding
Je bekijkt pagina 16 van 27
Put some water in the pan you want to check.
If does not flash “ ” in the display and the water is heating, the pan is suitable.
Cookware made from the following materials is not suitable: pure stainless steel, aluminum or copper without
a magnetic base, glass, wood, porcelain, ceramic, and earthenware.
NOTE: Do not use cookware with jagged edges or a curved base.
Make sure that the base of your pan is smooth, sits flat against the glass, and is the same size as the cooking
zone. Use pans whose diameter is as large as the graphic of the zone selected. Using a slightly wider pot and
energy will be used at its maximum efficiency. If you use smaller pot efficiency could be less than expected.
Pot less than 140 mm could be undetected by the hob. Always centre your pan on the cooking zone.
Always lift pans off the Induction hob – do not slide, or they may scratch the glass.
Good Bad Bad
B
d
Bad Bad Bad Bad G
̱ ¬¿®¬ ½±±µ·²¹
1. Power On
When the mains power supply is switched on, the buzzer beeps once and all the indicators light up for 1
second, then go out. This indicates that the ceramic hob has entered standby mode.
When the hob is in the standby mode the indicator lights do not shine, all the controls are disabled except
the “ON/OFF” and “keylock” control.
2. Touch the ON/OFF control.
After power on, the buzzer beeps once, all displays show “ –” or “ ––”, indicating that the induction hob
has entered power on status.
When the hob is on, touch “ON/OFF”, all heating areas will be off. Another touch means the hob enters
power on status.
3. Place a suitable pan on the cooking zone that you wish to use.
Make sure the bottom of the pan and the surface of the cooking zone are clean and dry.
4. Touching the heating zone selection control, and an indicator next to the key will flash
Select a heat setting by touching the “-” or “+” control.
If you don’t choose a heat setting within 1 minute, the Induction hob will automatically switch off. You
will need to start again at step 2.
You can modify the heat setting at any time during cooking.
5. If the display “ ”flashes alternately with the heat setting
This means that:
you have not placed a pan on the correct cooking zone or,
the pan is not suitable for induction cooking or,
the pan is too small or not properly centered on the cooking zone.
NOTE: No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 1 minute if no suitable pan is placed on it.
0
ݱ±´·²¹ º¿²
When the hob starts heating, the cooling fan will start work together. When heating area stops work,
cooling fan will keep working for 2 minutes then stop.
Bekijk gratis de handleiding van Parmco FS600SI, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parmco |
| Model | FS600SI |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3225 MB |
