Parkside PUV 2000 C2 handleiding
Handleiding
Je bekijkt pagina 8 van 32
GB
8
If the connection cable of this
device is damaged, it must be
replaced by the manufacturer
or their customer service or by
a similarly qualied person in
order to avoid hazards.
• Do not connect a damaged
mains cable to the power sup-
ply. Do not touch a damaged
mains cable as long as it is
connected to the power supply.
A damaged mains cable can
result in voltage-carrying parts
being touched.
Additional safety
information
Caution! Avoid injury, re
and health risks:
• If in danger, immediately re-
move the mains plug from the
socket.
• Never use the device as a hair
dryer
• Never direct the hot air ow at
people or animals.
• Do not look directly into the
nozzle opening on the blow-off
pipe.
• Do not touch the nozzle when it
is hot.
• Wear safety gloves.
• Wear safety goggles.
• Remove the mains plug from the
socket when not in use as well
as when taking a break from
working or while carrying out
work on the device, e.g. chang-
ing the nozzle.
• Maintain distance between the
nozzle outlet and the surface or
workpiece you are working on.
The device could overheat.
• The device must always be kept
clean, dry and free of oil or lu-
bricating greases.
Assembly
Assembling the tool:
1. Place the tool on a at surface.
2. Place the tool cable (15) in the tool so
that it is not pinched by the extension
tube (3) nor protrudes over the tool
housing (5) (see illustration
1
).
It is helpful to put the cable in a loop
so that it takes up less space.
3. Place the housing cover (16) on the
tool and secure it with the two Phillips
screws supplied (see illustration
2
).
The housing cover (16) must be easy
to put on. If necessary, check whether
the tool cable (15) was pinched during
installation.
Mounting the stand bracket:
4. Attach the stand bracket (8) by rst
hanging it in one of the two holes and
then placing it in the opposite hole on
the tool housing (5) by pulling gently
(see illustration
3
).
Initial start-up
When used for the rst time, some smoke
may escape. The smoke is caused by bind-
ers which are removed from the insulating
lm of the heater by the heat during rst
use.
Bekijk gratis de handleiding van Parkside PUV 2000 C2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PUV 2000 C2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3844 MB |
