Parkside PTPK 400 C1 handleiding
Handleiding
Je bekijkt pagina 22 van 47
22
GB/IE/NI/CY
EXPLOSIVE OR DANGEROUS
LIQUIDS.
WARNING!
THE PUMP
MUST NOT BE USED WHEN
PEOPLE ARE IN THE WATER.
Residual risks
WARNING!
DANGER TO
LIFE DUE TO ELECTROMAGNET-
IC FIELD.
Under certain conditions, the electro-
magnetic field that develops during
operation can adversely affect active
or passive medical implants.
Consult your doctor or the man-
ufacturer of the medical implants
before operating the appliance.
Preparation
Note: Remove all packaging material from the
product. Remove all protective films before using
the appliance for the first time.
Assembly
Attaching the Adapter and
the Retaining Cable
Press and hold the locking button
11
.
Push the connecting piece
12
onto the pressure
connection
3
completely .
Release the locking button
11
.
Make sure that the locking button
11
is in its
original position and the connecting piece
12
is sitting firmly on the pressure connection
3
.
Place the non-return valve
10
in the connection
opening of the connecting piece
12
.
Make sure that the UP label is visible from the
outside.
Screw the adapter
9
firmly onto the connect-
ing piece
12
counter-clockwise .
Fasten the retaining cable
13
to the Carrying
handle
1
.
Attaching the Pressure Hose
or Pressure Cable
Pressure hose and/or pressure pipe
as well as additional accessories (e.g.
hose clamps) are not included in
delivery.
•
Use a pressure hose when the
pump is being operated in an
unfixed installation setting.
•
Use a pressure pipe with non-re-
turn valve to operate the pump in
a permanent installation setting.
The adapter must be trimmed in order
to perform the following steps. Read
through the application options
carefully before trimming the
adapter.
Attaching the Pressure Hose ½"
Push a suitable hose clamp onto the pressure
hose.
Plug the pressure hose onto the adapter
9
.
Push the hose clamp so that it comes to rest
upon the pressure hose and the adapter piece.
Tighten the hose clamp.
Attaching the Pressure Hose ¾"-,
1"- or 1 ½"
Trim the adapter
9
to achieve a
better flow rate.
Using a saw (not included in delivery), cut off
the connection to the adapter
9
resting upon it.
Stick a suitable hose clamp onto the pressure
hose.
Plug the pressure hose onto the adapter
9
.
Push the hose clamp so that it comes to rest
upon the pressure hose and the adapter piece.
Tighten the hose clamp.
Attaching the Pressure Hose Con-
nection System 33.3 mm (G 1")
Using a saw (not included in delivery) cut the
adapter
9
off directly above the G 1”-pipe
thread.
If necessary, deburr the interface with the aid
of a file or sandpaper.
Safety / Preparation / Assembly
Bekijk gratis de handleiding van Parkside PTPK 400 C1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PTPK 400 C1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5112 MB |
