Parkside PSZ 250 A1 handleiding
Handleiding
Je bekijkt pagina 19 van 75
19 GB/IE
¾ Do not operate the product if the power
cord or power plug are damaged, nor if the
product does not work or is damaged in any
way.
¾ If the power cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
¾ Do not disconnect the power plug from the
socket outlet by pulling on the power cord.
Special safety information for rope
hoists
¾ Persons who intend to use the product
must first receive appropriate training or
instructions.
¾ It is prohibited to move persons with the
product.
¾ It is prohibited to lift loads in excess of the
nominal load.
¾ Do not attempt to lift stuck or jammed loads.
¾ The steel cable must be taut when lifting the
load.
¾ Do not pull the loads in horizontal direction.
¾ Avoid switching the product on and off
rapidly (inching operation).
¾ Always be attentive when operating the
product.
¾ Do not leave hanging loads unattended
without taking appropriate safety measures.
¾ Do not stand or work underneath raised
loads.
¾ The product has not been outfitted with a
rated power limit. Do not attempt to lift the
load further when the overheat protection
limits operation. In this case, the load has
exceeded the product’s nominal power.
¾ Do not use the maximum/minimum length
levers
15
16
routinely as a stop mechanism.
These levers serve as a stop mechanism only
in emergencies.
¾ Before you begin: Check whether
– the steel cable
14
is wound properly
around the drum
17
and whether
– the space between coils is less than the
diameter of the cable itself (Fig. D).
Assembly
(Fig. E)
m
DANGER!
u The square tube must be able to bear
a minimum load of 500 kg at the
points where the product is fastened. If
you are unsure, consult a professional
(e.g. a structural engineer).
u Seek advice from a qualified technician to
ensure all screws are tightened fully and
correctly.
u A qualified technician or a properly
trained person should check the anchoring
of the square tube before the product is
started.
¾ Fasten the product with the mounting
brackets
1
and the mounting screws
2
to
a suitable square tube.
¾ Tighten the mounting screws
2
.
Before first use
¾ Remove the transport lock from the steel
cable
14
. Cut the rubber band and remove
it.
Bekijk gratis de handleiding van Parkside PSZ 250 A1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PSZ 250 A1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7862 MB |
