Parkside PRTA 20-Li D3 handleiding
Handleiding
Je bekijkt pagina 22 van 96
20 GB/IE/NI
Troubleshooting
Problem Possible cause Action
The product does
not start.
o The battery[] is empty. o Charge the battery[]
(see “Charging the battery”).
o The battery[] is not properly
inserted.
o Insert the battery[] correctly
(see “Inserting/removing the
battery”).
o The on/off switch[2] is
defective.
o Have the product repaired by
the Service Centre.
o The motor is defective.
The product works
with intermittent
operation.
o Internal loose contact. o Have the product repaired by
the Service Centre.
o The on/off switch[2] is
defective.
The product
makes much
vibration and loud
noise.
o The trimming assembly is dirty. o Clean the trimming assembly
(see “Cleaning and
maintenance”).
o The motor is defective. o Have the product repaired by
the Service Centre.
The trimming result
is bad.
o The line spool[] does not have
enough cutting line.
o Extend the cutting line if required
(see“Extending the cutting
line”).
o Replace the line spool[]
(see “Cleaning and
maintenance”).
o Both or one of the cutting lines
are not protruding out of the
spool cap
[].
1. Remove the spool cap[].
2. Feed the cutting line through the
openings to the outside.
3. Reinstall the spool cap[].
o The trimming assembly is dirty. o Clean the trimming assembly
(see “Cleaning and
maintenance”).
o The battery[] is not fully
charged.
o Charge the battery[]
(see “Charging the battery”).
Bekijk gratis de handleiding van Parkside PRTA 20-Li D3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PRTA 20-Li D3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9653 MB |
