Parkside PLSBA 40-Li A1 handleiding
Handleiding
Je bekijkt pagina 19 van 56
GB
19
• You get optimal results when you use
the blower with a separation distance
to the ground of 5 -10 cm.
• Begin work with the highest blowing
power, in order to rapidly pile up the
leaves lying around. Select a lower
blowing power to compact the previ-
ously piled up leaves.
• Before blowing, loosen leaves adher-
ing to the ground with a broom or
rake.
• The guide rollers at the end of the tube
make it easier to work on at surfaces.
• Hold the tool by the handle (2) and
auxiliary handle (12) when working.
Suction operating mode:
For safety reasons, all pipe
sections must be correctly
mounted before you can
start the device.
• Always hold the device tight with both
hands during operation: use the handle
(2) and the additional handle
(12) for this.
• Make sure the volumes of leaf material
sucked in at one time are not too large.
This will avoid clogging of the suction
tube (9 + 10) and blockage of the im-
peller wheel.
To reduce wear on the collection
bag, do not drag it along the
ground while working.
Overload protection: The motor
will cut out immediately if overloaded.
Switch off the leaf vacuum and remove
the batteries from the device. Then check
whether the impeller is blocked or the
collection bag clogged and remove the
obstacles if they are.
The tool cannot be used until it has com-
pletely cooled down again.
Emptying the collection bag:
With full collection bag, the suction pump-
ing capacity decreases considerably and
the collection bag must be emptied when
the bag is full or interferes with the suction
capacity of the device.
Illustration
:
1. Turn off the device and wait until the
impeller has stopped.
2. Remove the batteries (7) from the de-
vice (see “Removing/inserting the bat-
tery”).
3. Remove the snap hook (27) from the
eyelet (28). Release the collection bag
(5) by pressing the latches (29) and
pulling the collection bag (5) off the
motor housing (3).
4. Open the zip-fastener on the collection
bag (5) and empty it completely.
5. Mount the emptied collection bag (5)
again.
Composting material does not
belong with domestic waste!
Cleaning and
maintenance
Warning! Risk of injury by
dangerous moving parts!
Always clean the device
immediately after working with
it, as otherwise dirt will become hardened
and rmly attached with leaf residues
and might prove impossible to remove
without dismantling the motor housing.
Such cleaning work is not covered by the
warranty.
Bekijk gratis de handleiding van Parkside PLSBA 40-Li A1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PLSBA 40-Li A1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7317 MB |
