Parkside PHSSA 20-Li D2 handleiding

Handleiding

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104105106107108109110111112113114115116117118119120121122123124125126127128129130131132133134135136137138139140141142143144145146147148/ 148

Afdrukken

Je bekijkt pagina 24 van 148

GB

MT

24

from the online shop (see Spare parts and

accessories, p.27).

Procedure (Fig.A)

1. Remove the collection container (1), see

Attaching and removing the collection

container, p.22.

2. Remove the filter holder (3) / filter (4), see

Attaching and removing the filter holder/

filter, p.22.

3. Replace the old filter (4) with a new one.

4. Fit the filter holder (3) / filter (4), see

Attaching and removing the filter holder/

filter, p.22.

5. Attach the collection container (1), see

Attaching and removing the collection

container, p.22.

Storage

Always store the device and accessories:

• clean

• dry

• protected against dust

• out of the reach of children

Notes

• Remove the battery from the device be-

fore storing the device (see the separate

operating instructions for the battery and

charger).

• The storage temperature for the re-

chargeable battery and appliance is

between 0 - 45 °C. Avoid extreme cold or

heat during storage, so that the battery

does not lose performance.

• The collection container (1) is not suitable

for storing liquids. Empty the collection

container after wet vacuuming.

Using the nozzle holder

The nozzle holder (7) can be used to store

the brush nozzle (8), crevice nozzle (9) and

wet nozzle (10).

Procedure (Fig.C)

1. Push the extension tube (12) through

the centre ring on the nozzle holder (7).

The angular holder is intended for the

crevice nozzle (9). Brush nozzle (8) and

wet nozzle (10) for the round holders on

the right and left.

Wall mounting

You can also mount the appliance on the

wall.

WARNING! Contact with electrical cables

can lead to electric shock and fire. Contact

with a gas line can result in an explosion.

Damage to a water pipe can lead to property

damage and electric shock. When drilling,

be careful not to damage any supply lines.

Use suitable search devices to find these or

consult an installation plan for guidance.

Tools and aids required

(not included)

• Drill machine

• Screwdriver

• Pencil

• Dowel

• Screw

Procedure (Fig.B)

1. Mark a suitable place on a wall with a

pencil.

2. Drill the marked holes with a drill. The

screw head can have a diameter of 6 to 7

mm.

3. Insert the dowel into the hole and tighten

the screw with a screwdriver. Leave the

screw head protruding at a distance of

approx. 10 mm from the wall.

4. You can now position the appliance with

the keyhole (18) on the screw and pull it

down as far as it will go.

Troubleshooting

The following table will assist you in fixing faults:

Problem Possible cause Error correction

On/Off switch (6) is brokenDevice does not start

Defective motor

Contact the service centre.

Appliance switches off Appliance is blocked Removing obstructions and

blockages

Restart device

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104105106107108109110111112113114115116117118119120121122123124125126127128129130131132133134135136137138139140141142143144145146147148/ 148

Bekijk gratis de handleiding van Parkside PHSSA 20-Li D2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Stofzuiger