Parkside PEH 30 D4 handleiding
Handleiding
Je bekijkt pagina 11 van 151
PEH 30 D4
GB
│
IE
│
7 ■
Operation
Switching on and off
Switching on
♦ First, press the safety lock-out
.
♦ Then press and hold the ON/OFF switch
.
You can now release the safety lock-out .
Switching off
♦ Release the ON/OFF switch
.
NOTE
► For safety reasons, the ON/OFF switch
cannot be locked.
Setting the cut depth
Use the dial to adjust the cutting depth
(0–3mm) in 1/10 mm increments using the
cutting depth scale .
Dust/chip extraction (see fig.A)
WARNING!
Always wear a dust mask!
WARNING! RISK OF INJURY!
► Always remove the plug from the power
socket before working on the appliance.
Adjustable chip ejector (left/right)
♦ Unlock the chip ejector
by turning it in the
opposite direction to the arrow (from the
“LOCK” position).
♦ Pull the chip ejector
out of the appliance.
♦ The chip ejector
can be attached to the
plane on the left or the right. Make sure that
the tab on the chip ejector
fits into the corre-
sponding recess on the housing.
♦ Push the chip ejector
into the appliance.
♦ Lock the chip ejector
by turning it to the
position “LOCK”.
External extraction
When using dust extraction systems, e.g. a work-
shop extractor, it may be necessary to use the
adapter for external extraction
. The vacuum
cleaner must be suitable for the material being
processed.
Connecting
♦ Push the adapter for external extraction
firmly into the chip ejector
.
♦ Push the hose of a suitable dust extraction
appliance (e.g. a workshop vacuum cleaner)
onto the chip ejector
(or the adapter for
external extraction , if required).
Removal
♦ Pull the hose of the vacuum cleaner off the chip
ejector
or the adapter.
♦ Pull the adapter for external extraction
off.
Parking shoe (see fig. B)
The parking shoe allows you to put down the
appliance without risking damage to the work-
piece. While working, the parking shoe is
flipped up and rear part of the plane sole is
exposed.
Planing
CAUTION! RISK OF KICKBACK!
► Always switch the appliance on before
applying it to the workpiece.
♦ Set desired cut depth.
♦ Switch the appliance on.
♦ Place the appliance with the front part of the
plane sole
on the workpiece.
♦ Move the appliance with straight, even motions
over the workpiece.
♦ Push forward slowly and do not exert excessive
pressure on the plane sole
. Excessive speed
reduces the surface finish and can lead to a jam
in the chip ejector.
IB_471090_PEH30D4_LB8.indb 7IB_471090_PEH30D4_LB8.indb 7 09.01.2024 14:14:1609.01.2024 14:14:16
Bekijk gratis de handleiding van Parkside PEH 30 D4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PEH 30 D4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15971 MB |
