Parkside PDRA 20-Li B3 handleiding
Handleiding
Je bekijkt pagina 17 van 42
14 GB/IE/NI
Charge the battery pack [] before
operation when it is at medium or low
charging level.
The charging control LEDs (red [] and
green []) indicate the status of the battery
charger [] and the battery pack []:
LEDs Status
Red LED lights up Battery pack charges
Green LED lights up
Battery pack fully
charged
Green and red LED
flashing
Battery pack
defective
Red LED flashing
Battery pack too cold
or too warm
Green LED lights up
(without battery pack)
Charger ready
1. Insert the battery pack [] into the battery
charger [].
2. Connect the power cord with power plug []
of the battery charger [] to a socket-outlet.
3. When the battery pack [] is fully charged:
Remove the battery pack [] from the
battery charger []. Disconnect the power
plug [] of the battery charger [] from the
socket-outlet.
Attaching/removing the
battery pack
(Fig. D)
Attaching the battery pack
1. Align the battery pack [] to the battery
port [6].
2. Insert the battery pack [] into the battery
port [6] until the battery pack [] is click-
locked.
Removing the battery pack
1. Press down the release button [] of the
battery pack [].
2. Remove the battery pack [] from the
battery port [6].
Attaching/removing the
lances
(Fig. E)
m
WARNING
Switch the product off and remove
the battery pack [] before replacing
attachments, cleaning and when not
in use.
The pressure washer [1] can be connected
to the foam lance [] for diluting cleaning
agent [] and applying on surface to be
cleaned.
The pressure washer [1] can also be
connected to the spray lance [7] for
cleaning and irrigation works.
Attaching the spray lance
(Fig. F)
1. Align the spray lance [7] to the pressure
washer [1].
2. Insert the spray lance [7] into the pressure
washer [1] until the connector is completely
inserted.
3. Rotate the spray lance [7] in clockwise
direction to lock the spray lance [7].
Removing the spray lance
1. Press down the spray lance [7].
2. Rotate the spray lance [7] in anti-clockwise
direction.
3. Remove the spray lance [7] from the
pressure washer [1].
Attaching the foam lance
(Fig. G)
1. Align the foam lance [] to the pressure
washer [1].
2. Insert the foam lance [] into the pressure
washer [1] until the connector is completely
inserted.
3. Rotate the foam lance [] in clockwise
direction to lock the foam lance [].
Bekijk gratis de handleiding van Parkside PDRA 20-Li B3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PDRA 20-Li B3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4273 MB |
