Parkside PDFW 120 B3 handleiding
Handleiding
Je bekijkt pagina 15 van 86
13GB/IE/NI/CY
Adjust the tool rests so that the angle
between the tool rest and the accessory
tool is always greater than 85°.
Safety instructions for all
applications
General safety instructions for
grinding, sand paper sanding,
working with wire brushes, polishing,
milling and abrasive cutting
a) This power tool is intended for use
as a grinder, sandpaper sander,
wire brush, polisher, milling
machine and abrasive cutting
appliance. Please follow all safety
instructions, instructions, diagrams
and data that you receive with
the appliance. If you do not observe
the following instructions, this can lead to
an electrical shock, fire and/or serious
injuries.
b) Do not use any accessories
that have not been provided
or recommended by the
manufacturer for this power
tool. Just because you can attach the
accessories to your power tool, does not
guarantee they are safe to use.
c) The permissible speed of the
accessory tool used must be at
least as high as the maximum
speed specified for the power
tool. Accessories that rotate faster than
the permissible rate can break and throw
pieces into the air.
d) The external diameter and
thickness of the accessory
tool used must comply with
the dimensions of the power
tool. Incorrectly dimensioned accessory
tools cannot be sufficiently shielded or
controlled.
e) Grinding discs, sanding drums or
other accessories must match the
grinding spindle or collet chuck of
your power tool exactly. Accessory
tools which do not fit precisely into the
take-up of the power tool will rotate
unevenly, vibrate severely and can lead to
a loss of control.
f) Discs, grinding cylinders, cutting
tools or other accessories mounted
on a mandrel must be completely
inserted in the collet or chuck. Any
“protrusion” or exposed parts of
the mandrel between the grinding
tool and the collet or chuck must
be kept to a minimum. If the mandrel
is not sufficiently tightened or the grinding
tool protrudes too far, the tool could come
loose and been thrown out at high speed.
g) Never use damaged accessory
tools. Before each use, check
accessory tools such as grinding
discs for chips or cracks, sanding
drums for cracks, wearing or
excessive wear and tear and wire
brushes for loose or broken wires.
If the power tool or the accessory
tool in use is dropped, check to
see if it is damaged or use an
undamaged accessory tool.
When you have checked and
inserted the accessory tool, ensure
that you and any other people in
the vicinity remain outside of the
range of the rotating accessory
tool and allow the tool to rotate
at maximum speed for one
minute. Damaged accessory tools
usually break during this test period.
Bekijk gratis de handleiding van Parkside PDFW 120 B3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PDFW 120 B3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9931 MB |
