Parkside PBSL 5000 B2 handleiding
Handleiding
Je bekijkt pagina 11 van 38
10 GB/IE/NI
o Turn the adjustable foot/hand grip [4]
and fix the product at desired position. The
adjustable foot/hand grip can also be turned
up and used as a hand grip (Fig. C).
o The product can be fixed by attaching it to a
flat ferromagnetic surface with the magnet [5]
of the adjustable foot/hand grip.
o The product can be hung up. Press the grip
lock [] to release the adjustable foot/hand
grip (Fig. D). Push the adjustable foot/hand
grip back in after hanging the product at a
desired position.
m
CAUTION! Please note the position of your
hands whilst turning the adjustable foot/hand
grip to prevent pinching your fingers.
NOTES:
o The product may be used as a light or as a
charger.
o The energy stored in the rechargeable
batteries power both the LED light and the
charging station. Using the product as a
charger therefore reduces the operating time
and brightness in lighting mode.
Using as a LED light
o Fully charge the product as described in the
section “Charging the product“.
o The product can be operated in 3 different
modes. Select these by repeatedly pressing
the ON/OFF switch [2].
ON/OFF switch Mode
Press 1×: 2 white lights light up.
Press 2×: 1 white light lights up.
Press 3×: 1 white light lights up.
Press 4×: Switch off the light.
Using as a power bank
ATTENTION! Charging a device which requires
a higher charging current may cause a defect in
both devices.
The charging current the device requires
may not exceed 2 A. Carefully read the
instructions for use of the device you wish to
charge.
The battery of the device you wish to charge
must have a significantly smaller capacity
than the total capacities of the rechargeable
batteries inside the product (5000 mAh).
Otherwise charging may not complete.
o When used with the USB cable [], the
product may be used to charge small
electronics devices with USB socket (Type C)
for charging (e.g. mobile phones or digital
cameras).
1. Open the protective cap [7].
2. Insert the USB plug of the USB cable [] into
the USB output socket [9].
3. Insert the USB plug of the USB cable into the
small electronic devices you wish to charge.
The red charging indicator [6] lights up,
indicating the battery capacity.
4. Remove the USB cable as soon as charging
is complete.
5. Close the protective cap.
Maintenance and cleaning
Never immerse the product in water or other
liquids.
Never use caustic cleaners.
The product requires no maintenance. The
LEDs cannot be replaced.
o Before cleaning:
– Switch off the product.
– Disconnect the USB cable [] from the USB
socket.
– Close the protective cap [7] on the USB
input socket [8] and USB output socket [9].
o Regularly clean the product with a dry,
lint‑free cloth. Use a slightly moist cloth to
remove any stubborn dirt.
Disposal
The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Bekijk gratis de handleiding van Parkside PBSL 5000 B2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PBSL 5000 B2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3720 MB |
