Parkside PBSL 5000 B2 handleiding
Handleiding
Je bekijkt pagina 10 van 38
9GB/IE/NI
This product has a built‑in rechargeable
battery which cannot be replaced by the
user. The removal or replacement of the
rechargeable battery may only be carried out
by the manufacturer or his customer service
or by a similarly qualified person in order
to avoid hazards. When disposing of the
product, it should be noted that this product
contains a rechargeable battery.
Before use
Charging the product
NOTES:
o Remove all packaging materials from the
product.
o In order to use the product without a
USB cable [], you need to recharge the
rechargeable battery before use. The
charging process takes about 7 hours. The
rechargeable battery is firmly integrated into
the base of the product.
o Fully charge the rechargeable battery prior
to first use.
o Charge the battery if it becomes empty
(only 1 LED of the charging indicator [6] is
flashing).
1. Open the protective cap [7].
2. Connect the USB plug of the USB cable to the
USB input socket [8] on the product.
NOTES:
The battery charging status is shown by the
charging indicator [6]:
Charging
indicator [6] status
Battery
charging status
1 LED flashes 0‒33 %
1 LED lights up,
1 LED flashes 34‒65 %
2 LEDs light up,
1 LED flashes 66‒99 %
3 LEDs light up 100 %
o The charging time is approximately 7 hours
when the battery was drained.
o The product has an overcharging protection
system. Nevertheless, you should disconnect
the product from the mains once the charging
process is complete.
o The product is not working at temperatures
below +5 °C and above +45 °C due to its
battery protection.
1. Disconnect the USB cable [] from the
product to prevent the batteries discharging
themselves.
2. Close the protective cap [7] before you start
to use the product again. Otherwise water
could enter to the product when it is used
outdoors.
Checking the battery capacity
o When product is not charged: Press the
ON/OFF switch [2] to check the battery
capacity. The red charging indicator [6]
shows the capacity* of the battery inside the
product.
1 LED lights up = 33 %*
2 LEDs light up = 66 %*
3 LEDs light up = 100 %*
* This is the approximate percentage of battery
capacity but not actual measurement.
Mounting the product
m
CAUTION! A single adjustable foot/hand
grip [4] is not sufficient for attaching the
product to magnetisable surfaces (Fig. E).
o Each of the adjustable 2 foot/hand grips [4]
is equipped with 4 magnets [5]. With these
magnets, the product can be attached to
magnetisable surfaces.
Operation
m
RISK OF ACCIDENTS! Preferably do
not use the product whilst driving a vehicle.
When using the product in a vehicle, be
sure this does not endanger the driver or
the passengers. Always store and secure
the product so that even full braking does
not pose a risk of injury from the product or
product damage.
Bekijk gratis de handleiding van Parkside PBSL 5000 B2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PBSL 5000 B2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3720 MB |
